Surface integrity and recast layer characteristics of Syalon-501 during EDM
Surface Engineering · 19.11.2026
DOI: 10.1177/02670844261508225 ↗Kurz gefasst
Fachartikel in der Zeitschrift Surface Engineering, online erschienen am 19.11.2026. Verfasst von Selvarajan Lakshmanan und 3 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben.
Abstract (Originalsprache)
Electrical discharge machining (EDM) is widely utilised non-traditional machining technique for conductive ceramic composites (CCCs), since it can machine complex geometries without imposing high mechanical strains. The impact of gap voltage (35.5–45.5 V, current (3–7A), pulse-off-time (3–7 μs), pulse-on-time (6–10 μs), and dielectric pressure (15–19 kg/cm 2 ) on the recast layer and surface morphology of Si 3 N 4 -TiN (Syalon 501) CCCs were studied by L25 orthogonal array and scanning electron microscopy (SEM). From the SEM results, it seems that the increase of current from 3 to 7 A significantly increased the discharge energy, leading to deeper craters, thicker recast layers, wider microcracks and resolidified molten droplets. Similarly, localized melting and material redeposition increased with increasing the spark-gap voltage from 35.5 to 45.5 V, resulting in an uneven surface morphology. Higher dielectric pressure (19 kg/cm 2 ) improved flushing efficiency and reduced the thickness of adherent debris and recast layer. Short pulse-off periods (3–4 μs) limited dielectric deionization, caused secondary discharges and increased debris entrapment. The surface integrity was found to be maximum at 4A, 7µs pulse-off-time, 7µs pulse-on-time, 42 V spark-gap voltage and 16 kg/cm 2 dielectric pressure. At the conditions the machined surface resulting fine craters, low microcracks, fewer microvoids and a thin continuous recast layer. The results show clearly the high dependence of the thermo-induced surface degradation on the EDM discharge parameters.
Zitieren
APA
Lakshmanan, S., Chandrasekaran, A., Sivasankaran, S. T., & Balakrishnan, P. (2026). Surface integrity and recast layer characteristics of Syalon-501 during EDM. Surface Engineering. https://doi.org/10.1177/02670844261508225
Vancouver
Lakshmanan S, Chandrasekaran A, Sivasankaran ST, Balakrishnan P. Surface integrity and recast layer characteristics of Syalon-501 during EDM. Surface Engineering. 2026. doi:10.1177/02670844261508225
BibTeX
@article{Lakshmanan2026,
author = {Lakshmanan, Selvarajan and Chandrasekaran, Arun and Sivasankaran, Senthilkumar Thangarajan and Balakrishnan, Prakash},
title = {Surface integrity and recast layer characteristics of Syalon-501 during EDM},
journal = {Surface Engineering},
year = {2026},
doi = {10.1177/02670844261508225}
}
EUVIMED