EUVIMEDEUVIMED entdecken
Crossref

Strength–wear trade-off in DLMD Stellite 6–SiC coatings

Mohammad Pourentezari Zarch, Jamal Zamani

Surface Engineering · 2026-05 · 42 (5) · 582-594

DOI: 10.1177/02670844261450434 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Surface Engineering, online erschienen am 14.05.2026. Verfasst von Mohammad Pourentezari Zarch und 1 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 47 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Direct laser metal deposition (DLMD) was used to fabricate Stellite 6 metal–matrix composites reinforced with 0, 5 and 10 wt.% SiC. This study quantifies how SiC content governs the microstructure, tensile response, and tribological performance. Spherical Stellite 6 (53–180 µm) and irregular SiC (3–10 µm) powders were blended and deposited on 17-4PH steel. SiC addition refined dendrites and increased hardness monotonically: the 10 wt.% composite reached HV̄ ≈ 910 (peak ≈ 1041 HV), >60% above unreinforced Stellite 6. Tribology improved accordingly: the 10 wt.% SiC coating showed a ∼6× lower wear volume than the matrix alloy. Conversely, bulk strength exhibited a non-monotonic trend: UTS peaked at 1255 ± 22.9 MPa for 5 wt.% SiC but decreased at 10 wt.% (1180 ± 84.9 MPa), consistent with SiC agglomeration acting as stress concentrators. Fracture and surface analyses link the strength–wear trade-off to particle dispersion and process-induced heterogeneity at higher loading. These results show DLMD can tailor Stellite 6–SiC for application-specific targets: 5 wt.% for load-bearing strength versus 10 wt.% for maximum wear resistance. The study provides a quantitative map of property trade-offs to guide parameter/composition selection in laser-deposited Co-based MMCs.

Zitieren

APA

Zarch, M. P., & Zamani, J. (2026). Strength–wear trade-off in DLMD Stellite 6–SiC coatings. Surface Engineering, 42(5), 582-594. https://doi.org/10.1177/02670844261450434

Vancouver

Zarch MP, Zamani J. Strength–wear trade-off in DLMD Stellite 6–SiC coatings. Surface Engineering. 2026;42(5):582-594. doi:10.1177/02670844261450434

BibTeX
@article{Zarch2026,
  author = {Zarch, Mohammad Pourentezari and Zamani, Jamal},
  title = {Strength–wear trade-off in DLMD Stellite 6–SiC coatings},
  journal = {Surface Engineering},
  year = {2026},
  volume = {42},
  number = {5},
  pages = {582--594},
  doi = {10.1177/02670844261450434}
}
Kostenlos starten →