EUVIMEDEUVIMED entdecken
Crossref

Effect of ultrasonic shot peening on the microstructure, surface residual stress, and wear properties of Ti-6Al-4V alloy

Haodong Sun, Chaorun Si, Junbiao Wang

Surface Engineering · 2024-11 · 40 (11-12) · 1098-1112

DOI: 10.1177/02670844241298674 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Surface Engineering, online erschienen am 25.11.2024. Verfasst von Haodong Sun und 2 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 40 Literaturangaben. Gefördert von: Natural Science Basic Research Plan of Shaanxi Province.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, ultrasonic shot peening (USP) was used to enhance the surface of a Ti-6Al-4V alloy. Samples treated with different amplitudes were characterized and their wear resistance was tested and analyzed. The results demonstrate that the surface morphology of the Ti-6Al-4V alloy changed significantly after USP treatment, and the surface roughness increases at first, then stabilizes as the amplitude increases. The surface grain of the material is refined due to severe plastic deformation, and the average grain size after USP treatment is 27.93% finer than the original sample. Due to the effect of fine grain strengthening and work hardening, the microhardness of the material's near-surface layer is also enhanced in varying degrees, showing a gradient decrease throughout the depth of the cross-section. Furthermore, USP produces compressive residual stress as high as −791.01 MPa in the near-surface layer. When the USP amplitude is 80% and the treatment time is 240 s, the wear resistance of Ti-6Al-4V alloy is substantially enhanced under the combined action of hardness, compressive residual stress, and surface pits, reducing wear resistance. The wear mechanism is primarily abrasive wear and oxidation wear.

Förderung

  • Natural Science Basic Research Plan of Shaanxi Province

Zitieren

APA

Sun, H., Si, C., & Wang, J. (2024). Effect of ultrasonic shot peening on the microstructure, surface residual stress, and wear properties of Ti-6Al-4V alloy. Surface Engineering, 40(11-12), 1098-1112. https://doi.org/10.1177/02670844241298674

Vancouver

Sun H, Si C, Wang J. Effect of ultrasonic shot peening on the microstructure, surface residual stress, and wear properties of Ti-6Al-4V alloy. Surface Engineering. 2024;40(11-12):1098-1112. doi:10.1177/02670844241298674

BibTeX
@article{Sun2024,
  author = {Sun, Haodong and Si, Chaorun and Wang, Junbiao},
  title = {Effect of ultrasonic shot peening on the microstructure, surface residual stress, and wear properties of Ti-6Al-4V alloy},
  journal = {Surface Engineering},
  year = {2024},
  volume = {40},
  number = {11-12},
  pages = {1098--1112},
  doi = {10.1177/02670844241298674}
}
Kostenlos starten →