EUVIMEDEUVIMED entdecken
Crossref

Cell structure and mechanical properties of microcellular PLA foams prepared via autoclave constrained foaming

Jinwei Chen, Ling Yang, Dahua Chen, Qunshan Mai, Meigui Wang, Lixuan Wu, Ping Kong

Cellular Polymers · 2021-05 · 40 (3) · 101-118

DOI: 10.1177/0262489320930328 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Cellular Polymers, online erschienen am 05.06.2020. Verfasst von Jinwei Chen und 6 weiteren Autor:innen. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 36 Literaturangaben. Gefördert von: Top Talent Project of Guangdong Industry Polytechnic in 2017.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microcellular polylactic acid (PLA) foams with various cell size and cell morphologies were prepared using supercritical carbon dioxide (sc-CO 2 ) solid-state foaming to investigate the relationship between the cell structure and mechanical properties. Constrained foaming was used and a wide range of cell structures with a constant porosity of ∼75% by tuning saturation pressure (8–24 MPa) was developed. Experiments varying the saturation pressure while holding other variables’ constant show that the mean cell size and the mean cell wall thickness decreased, while the cell density and the open porosity increased with increase of pressure. Tensile modulus of PLA foams decreased with increasing the saturation pressure, but the specific tensile modulus of PLA foams was still 15–80% higher than that of solid PLA. Tensile strength and elongation at break first increased with increasing saturation pressure up to 16 MPa and then decreased with further increasing saturation pressure (20 MPa and 24 MPa) at which opened-cell structure produced. Compressive modulus, compressive strength, and compressive yield stress also followed the same variation trend. The results indicated that not only cell size plays an important role in properties of PLA foams but also cell morphology can influence these properties significantly.

Förderung

  • Top Talent Project of Guangdong Industry Polytechnic in 2017

Zitieren

APA

Chen, J., Yang, L., Chen, D., Mai, Q., Wang, M., Wu, L., & Kong, P. (2021). Cell structure and mechanical properties of microcellular PLA foams prepared via autoclave constrained foaming. Cellular Polymers, 40(3), 101-118. https://doi.org/10.1177/0262489320930328

Vancouver

Chen J, Yang L, Chen D, Mai Q, Wang M, Wu L, et al. Cell structure and mechanical properties of microcellular PLA foams prepared via autoclave constrained foaming. Cellular Polymers. 2021;40(3):101-118. doi:10.1177/0262489320930328

BibTeX
@article{Chen2021,
  author = {Chen, Jinwei and Yang, Ling and Chen, Dahua and Mai, Qunshan and Wang, Meigui and Wu, Lixuan and Kong, Ping},
  title = {Cell structure and mechanical properties of microcellular PLA foams prepared via autoclave constrained foaming},
  journal = {Cellular Polymers},
  year = {2021},
  volume = {40},
  number = {3},
  pages = {101--118},
  doi = {10.1177/0262489320930328}
}
Kostenlos starten →