EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Modeling and experimental validation of an indirect active hybrid solar dryer for mint leaves: Coupled thermal and moisture-transfer analysis

El-Sayed G. Khater, Adel H. Bahnasawy, Wulfran Fendzi Mbasso, Abdallah Elshawadfy Elwakeel, Aml Abubakr Tantawy, Eldessoky S. Dessoky, Atef Fathy Ahmed, Xiaochen Yang, Amr Sabahy, Osama Morsy, Mohamed Metwally Mahmoud, Khaled A. Metwally

Energy Exploration & Exploitation · 17.08.2026

DOI: 10.1177/01445987261479057 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Energy Exploration & Exploitation, online erschienen am 17.08.2026. Verfasst von El-Sayed G. Khater und 11 weiteren Autor:innen. Die Arbeit nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: This research was funded by the Deanship of Graduate Studies and Scientific Research, Taif University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A mathematical model was developed and experimentally validated to predict the thermal performance and drying behavior of an indirect active solar dryer (IAHSD) for mint leaves. The distinctive contribution of the proposed approach is its integration of solar-energy input, auxiliary gas heating, controlled fresh–recirculated air mixing, ambient-humidity effects, chamber heat losses, and mint-leaf moisture removal within a computationally accessible model suitable for operational assessment and control-oriented applications. The model describes coupled heat and mass transfer processes while considering key operating parameters, including drying air temperature (50–60°C), air recirculation ratio (70–90%), and ambient relative humidity (20–80%). Simulation results showed that increasing drying air temperature and recirculation ratio enhanced the drying chamber temperature, whereas higher ambient humidity reduced the thermal level and slowed moisture removal. Predicted chamber temperatures ranged from 37.83°C to 67.31°C depending on the inlet air temperature, while experimental values followed similar trends but were slightly lower due to environmental variations. Maximum temperatures occurred near midday, highlighting the influence of solar radiation on system performance. The model also captured moisture removal dynamics, indicating that higher drying temperatures accelerated drying rates, while elevated humidity reduced evaporation efficiency. Under low temperature and high humidity conditions, temporary moisture absorption was observed due to reversed vapor pressure gradients. Model validation showed strong agreement between predicted and measured data, with coefficients of determination (R 2 ) ranging from 0.85 to 0.96, confirming the reliability of the proposed model.

Förderung

  • This research was funded by the Deanship of Graduate Studies and Scientific Research, Taif University

Zitieren

APA

Khater, E. G., Bahnasawy, A. H., Mbasso, W. F., Elwakeel, A. E., Tantawy, A. A., Dessoky, E. S., Ahmed, A. F., Yang, X., Sabahy, A., Morsy, O., Mahmoud, M. M., & Metwally, K. A. (2026). Modeling and experimental validation of an indirect active hybrid solar dryer for mint leaves: Coupled thermal and moisture-transfer analysis. Energy Exploration & Exploitation. https://doi.org/10.1177/01445987261479057

Vancouver

Khater EG, Bahnasawy AH, Mbasso WF, Elwakeel AE, Tantawy AA, Dessoky ES, et al. Modeling and experimental validation of an indirect active hybrid solar dryer for mint leaves: Coupled thermal and moisture-transfer analysis. Energy Exploration & Exploitation. 2026. doi:10.1177/01445987261479057

BibTeX
@article{Khater2026,
  author = {Khater, El-Sayed G. and Bahnasawy, Adel H. and Mbasso, Wulfran Fendzi and Elwakeel, Abdallah Elshawadfy and Tantawy, Aml Abubakr and Dessoky, Eldessoky S. and Ahmed, Atef Fathy and Yang, Xiaochen and Sabahy, Amr and Morsy, Osama and Mahmoud, Mohamed Metwally and Metwally, Khaled A.},
  title = {Modeling and experimental validation of an indirect active hybrid solar dryer for mint leaves: Coupled thermal and moisture-transfer analysis},
  journal = {Energy Exploration & Exploitation},
  year = {2026},
  doi = {10.1177/01445987261479057}
}
Kostenlos starten →