EUVIMEDEUVIMED entdecken
Crossref

Enhancement of effective stiffness in FFF-printed components by filling inter-bead air gaps with carbon fiber filament: A numerical investigation

Momen Qasaimeh, Faris M. AL-Oqla

Journal of Composite Materials · 19.11.2026

DOI: 10.1177/00219983261510168 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Composite Materials, online erschienen am 19.11.2026. Verfasst von Momen Qasaimeh und 1 weiteren Autor:innen. Die Arbeit nennt 68 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

FFF-printed components often suffer from porosity and limited effective elastic properties caused by inter-bead air gaps and weak inter-filament bonding. To address these limitations, this study proposes a novel dual-nozzle gap-filling deposition strategy in which a primary nozzle deposits the structural primary filament while a is gap-filling nozzle deposits carbon-fiber-reinforced gap-filling filaments within the inter-bead regions. The gap-filling filaments serve multiple purposes: reducing part porosity (with a predicted reduction of up to 60%), improving filament connectivity and providing localized reinforcement through carbon fibers. Fiber-scale and meso-scale numerical investigations were conducted to evaluate the potential benefits of the proposed deposition approach. Additionally, the estimated effects of matrix material and carbon fiber content were investigated. Sensitivity analyses investigated the estimated effects of fiber misalignment, waviness, imperfect fiber-matrix bonding, and fiber-diameter variability at the fiber scale in addition to imperfect inter-filament bonding at the meso-scale. Finally, a thermal assessment was conducted to evaluate process feasibility. The numerical results show estimated improvement ranges relative to the no-gap-filling baseline case in the effective stiffness of ABS along the printing direction ( z -direction) with a range of 116–166%, in the transverse (x) direction normal to the printing direction with a range of 12–35%, in the building (y) direction with a range of 14–48%. Additionally, the results show a predicted improvement in the in-plane shear modulus with a range of 23–52%. A similar trend was observed for TPU, but due to its low initial effective stiffness, the predicted improvement is significantly higher along the z -direction. These estimated improvements occur as a result of carbon-fiber reinforcement, reduction in porosity, stress redistribution, gap bridging and improved filament connectivity.

Zitieren

APA

Qasaimeh, M., & AL-Oqla, F. M. (2026). Enhancement of effective stiffness in FFF-printed components by filling inter-bead air gaps with carbon fiber filament: A numerical investigation. Journal of Composite Materials. https://doi.org/10.1177/00219983261510168

Vancouver

Qasaimeh M, AL-Oqla FM. Enhancement of effective stiffness in FFF-printed components by filling inter-bead air gaps with carbon fiber filament: A numerical investigation. Journal of Composite Materials. 2026. doi:10.1177/00219983261510168

BibTeX
@article{Qasaimeh2026,
  author = {Qasaimeh, Momen and AL-Oqla, Faris M.},
  title = {Enhancement of effective stiffness in FFF-printed components by filling inter-bead air gaps with carbon fiber filament: A numerical investigation},
  journal = {Journal of Composite Materials},
  year = {2026},
  doi = {10.1177/00219983261510168}
}
Kostenlos starten →