Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study
Journal of Composite Materials · 17.11.2026
DOI: 10.1177/00219983261505784 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Composite Materials, online erschienen am 17.11.2026. Verfasst von Hasna Bouhali und 9 weiteren Autor:innen. Die Arbeit nennt 50 Literaturangaben. Gefördert von: Umm Al-Qura University.
Abstract (Originalsprache)
This study investigates the development and performance of bio-based composite materials reinforced with cellulose fibers extracted from Cynara scolymus (artichoke) stems, addressing the scientific gap regarding the influence of fiber length on the mechanical and hygroscopic properties of epoxy biocomposites. To make test specimens, the fibers were removed through the water retting method, followed by cutting them into three lengths (0.5, 1 and 1.5 cm) and embedded into an epoxy matrix at a 10% volume fraction. Tensile and flexural tests and the absorption of moisture in different aqueous conditions and the microstructure were used in describing the composites through optical microscopy and SEM. These findings revealed that the critical parameter that determines performance is fiber length: the 1.5 cm reinforcement delivered the highest tensile strength (32 MPa, which is 45% higher than that of 0.5 cm samples) and ductile behavior (3.5% deformation) and the 1 mm fibers delivered the best flexural strength (18 Mpa). The maximum moisture absorption was with 1.5 cm fiber composites (1.8% in fresh water) and minimum in 0.5 cm samples (1.2% in seawater). The microstructural analysis proved that the dispersion was homogeneous, however, it also showed that the interfaces were limited by means of fiber pull-out and micro voids. It is concluded that Cynara scolymus fibers are promising in terms of use as renewable reinforcements, but the performance highly depends on the choice of fiber length and that to reach similar mechanical properties with literature values; attention on interfacial adhesion via fiber treatment or favorable processing is required.
Förderung
- Umm Al-Qura University
Zitieren
APA
Bouhali, H., Hafez, R. M., Alqurashi, H. F., Talbi, N., Kezzar, M., Rashid, F. L., Kahaleras, M. S., Sari, M. R., Khan, I., & Mahariq, I. (2026). Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study. Journal of Composite Materials. https://doi.org/10.1177/00219983261505784
Vancouver
Bouhali H, Hafez RM, Alqurashi HF, Talbi N, Kezzar M, Rashid FL, et al. Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study. Journal of Composite Materials. 2026. doi:10.1177/00219983261505784
BibTeX
@article{Bouhali2026,
author = {Bouhali, Hasna and Hafez, Ramy M. and Alqurashi, Hazzaa F. and Talbi, Nabil and Kezzar, Mohamed and Rashid, Farhan Lafta and Kahaleras, Mohamed Said and Sari, Mohamed Rafik and Khan, Ilyas and Mahariq, Ibrahim},
title = {Development and performance analysis of bio-based composite materials using Cynara scolymus cellulose fibers: Experimental study},
journal = {Journal of Composite Materials},
year = {2026},
doi = {10.1177/00219983261505784}
}
EUVIMED