EUVIMEDEUVIMED entdecken
Crossref

Process Variables Optimization in Lapping of EN8 Material Using Taguchi Method

Rajesh Ramadass, Saravanan Sambasivam

Engineering Mathematics · 12.09.2018 · 2 (1) · 50-55

DOI: 10.11648/j.engmath.20180201.15 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Mathematics, online erschienen am 12.09.2018. Verfasst von Rajesh Ramadass und 1 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The main aim of this work is to minimize the surface roughness in the flat lapping of EN8 material. The process variables considered for the study were lapping time, abrasive size and abrasive carrier oil proportion. The mathematical model related to the lapping such as surface finish model, stress model and its significance was understood. The (L 9 ) orthogonal array in Taguchi method was utilized to conduct the experiments and surface roughness values were measured. The significance of each process variable on the surface roughness was studied using S/N ratio results. From the results, it was inferred that most influence factor among process variables is abrasive carrier oil proposition in slurry. Response table showed a delta value of 0.1967 for the abrasive carrier oil proposition in slurry. The optimum combination of process variables was determined based on S/N ratio and it was understood that minimum aluminum oxide abrasive proportion in slurry provides better surface quality in lapping of EN8 material. The optimum combination for minimum surface roughness were 15 minutes lapping time, 80 µm abrasive size and 1:3 abrasive carrier oil proportion in slurry.

Zitieren

APA

Ramadass, R., & Sambasivam, S. (2018). Process Variables Optimization in Lapping of EN8 Material Using Taguchi Method. Engineering Mathematics, 2(1), 50-55. https://doi.org/10.11648/j.engmath.20180201.15

Vancouver

Ramadass R, Sambasivam S. Process Variables Optimization in Lapping of EN8 Material Using Taguchi Method. Engineering Mathematics. 2018;2(1):50-55. doi:10.11648/j.engmath.20180201.15

BibTeX
@article{Ramadass2018,
  author = {Ramadass, Rajesh and Sambasivam, Saravanan},
  title = {Process Variables Optimization in Lapping of EN8 Material Using Taguchi Method},
  journal = {Engineering Mathematics},
  year = {2018},
  volume = {2},
  number = {1},
  pages = {50--55},
  doi = {10.11648/j.engmath.20180201.15}
}
Kostenlos starten →