Effect of Fiber Reinforcement on the Flexural Strength of Long-Span, 3D-Printed, Interim Fixed Dental Prosthesis
The International Journal of Prosthodontics · 2024
DOI: 10.11607/ijp.9203 ↗Kurz gefasst
Fachartikel in der Zeitschrift The International Journal of Prosthodontics, 2024. Verfasst von Suphansa Sivakorn und 2 weiteren Autor:innen. Hauptthemen laut MEDLINE: Printing, Three-Dimensional, Flexural Strength, Denture, Partial, Fixed, Denture Design.
Abstract (Originalsprache)
PURPOSE: To inspect the impact of polyethylene fiber (Ribbond) on long-span 3D-printed interim fixed dental prostheses regarding fracture strength. MATERIALS AND METHODS: A stainless steel platform was fabricated to replicate the partial edentulism for a maxillary four-unit fixed dental prosthesis. Prostheses were fabricated with a Formlabs SLA 3D printer. The specimens were allocated into four groups of 20 each: experimental reinforced Group A (prosthesis with a slot reinforced with fiber); experimental Group B (prosthesis with a slot filled with 3D-printed material), negative control Group C (prosthesis with a slot); and control Group D (full-contour prosthesis). Fracture strength exams were performed with a universal tester. The fracture patterns were examined. A statistical analysis was conducted using one-way ANOVA and Tukey HSD test. RESULTS: The control group exhibited a significantly higher mean flexural load (D: 306.32 ± 50.76 N) compared to the other groups (A: 194.37 ± 68.02 N; B: 178.25 ± 42.67 N; and C: 156.68 ± 29.73 N; P < .001). No differences were identified among Groups A, B, and C. The fracture pattern differed between the nonreinforced Groups B, C, and D and reinforced Group A, with catastrophic failure observed in the nonreinforced group and unseparated failure observed in the reinforced group. CONCLUSIONS: The study findings demonstrate that the incorporation of Ribbond in 3D-printed interim fixed dental prostheses does not significantly enhance their fracture strength. However, it does lead to a noticeable change in the fracture behavior, shifting from a complete failure to an incomplete fracture pattern.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Zitieren
APA
Sivakorn, S., Lin, R., & Park, C. (2024). Effect of Fiber Reinforcement on the Flexural Strength of Long-Span, 3D-Printed, Interim Fixed Dental Prosthesis. The International Journal of Prosthodontics. https://doi.org/10.11607/ijp.9203
Vancouver
Sivakorn S, Lin R, Park C. Effect of Fiber Reinforcement on the Flexural Strength of Long-Span, 3D-Printed, Interim Fixed Dental Prosthesis. The International Journal of Prosthodontics. 2024. doi:10.11607/ijp.9203
BibTeX
@article{Sivakorn2024,
author = {Sivakorn, Suphansa and Lin, Richard and Park, Cheryl},
title = {Effect of Fiber Reinforcement on the Flexural Strength of Long-Span, 3D-Printed, Interim Fixed Dental Prosthesis},
journal = {The International Journal of Prosthodontics},
year = {2024},
doi = {10.11607/ijp.9203}
}
EUVIMED