A Numerical Modeling Investigation of Liner Buckling With Ground Subsidence
Modelling and Simulation in Engineering · 2026-01 · 2026 (1)
DOI: 10.1155/mse/3893076 ↗Kurz gefasst
Fachartikel in der Zeitschrift Modelling and Simulation in Engineering, online erschienen am 18.08.2026. Verfasst von Ge Tang und 5 weiteren Autor:innen. Die Arbeit nennt 31 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Southwest Petroleum University.
Abstract (Originalsprache)
Mechanically lined bimetallic pipes are increasingly used in buried onshore oil and gas transportation systems exposed to corrosive media. This study focuses on a straight section of a buried mechanically lined pipe consisting of an X65 carbon‐steel backing pipe and a SUS304 stainless‐steel liner. The pipe is assumed to cross a localized ground‐subsidence zone, and the transported oil or gas is represented by a uniformly distributed internal pressure. By simulating the forming process of bimetallic tubes, residual contact stress is generated between the inner and outer pipes at the interface. In addition, by setting the contact behavior between soil and outer pipe, the interaction between pipe and soil is simulated. This paper provides a detailed analysis of the buckling mechanism of the liner during ground subsidence through parameter analysis, and proposes a prediction formula for the ovalization of the liner based on BP neural network and formulas. The results show the following: In nonsubsidence zones, the liner pipe deforms due to uneven bending moments transmitted from the outer pipe in subsidence zones. When subsidence displacement is small, interaction exists between the liner pipe and the outer pipe. However, because of the material differences between the two pipes, as subsidence displacement increases, the structural weakness of the liner pipe causes it to undergo axial deformation and lose support from the outer pipe, ultimately resulting in a concave shape. Ovalization, detachment rate, and curvature each exhibit two distinct phases of variation, and all three metrics decrease with increasing internal pressure, liner thickness, and outer pipe thickness. The conclusions are intended for mechanically lined straight pipes under quasi‐static subsidence and should not be directly extended to metallurgically bonded clad pipes, offshore pipelines, elbows, or girth welds.
Förderung
- Southwest Petroleum University
Zitieren
APA
Tang, G., Deng, Y., Xie, R., Li, G., Ren, X., & Han, C. (2026). A Numerical Modeling Investigation of Liner Buckling With Ground Subsidence. Modelling and Simulation in Engineering, 2026(1). https://doi.org/10.1155/mse/3893076
Vancouver
Tang G, Deng Y, Xie R, Li G, Ren X, Han C. A Numerical Modeling Investigation of Liner Buckling With Ground Subsidence. Modelling and Simulation in Engineering. 2026;2026(1). doi:10.1155/mse/3893076
BibTeX
@article{Tang2026,
author = {Tang, Ge and Deng, Yuting and Xie, Rui and Li, Guorong and Ren, Xuyun and Han, Chuanjun},
title = {A Numerical Modeling Investigation of Liner Buckling With Ground Subsidence},
journal = {Modelling and Simulation in Engineering},
year = {2026},
volume = {2026},
number = {1},
doi = {10.1155/mse/3893076}
}
EUVIMED