Development and Validation of a Low‐Cost IoT Electrochemical Formaldehyde Monitoring System for Clinical Indoor Environments
Journal of Sensors · 2026-01 · 2026 (1)
DOI: 10.1155/js/6412281 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Sensors, online erschienen am 19.06.2026. Verfasst von Maria Castillo und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Formaldehyde is a widely used chemical in pathology laboratories and a known occupational hazard with established carcinogenic potential. This study presents the design and validation of a low‐cost, Internet of Things (IoT)‐based monitoring system for real‐time formaldehyde detection in indoor clinical environments. The device integrates a ZE08‐CH2O electrochemical gas sensor, an ESP32‐WROOM‐32 microcontroller, and an LCD interface, all supported by embedded firmware for continuous environmental sampling. Field testing was conducted at a national pediatric pathology laboratory, where four critical work zones, grossing station, sample reception, tissue processor, and reagent storage, were monitored over a fixed time interval. Results from the custom‐built system were compared with a certified commercial monitor (Yvelines HTO 131) using Bland–Altman analysis to assess agreement. Mean differences across zones were within ±0.03 mg/m 3 , with 95% limits of agreement (LoA) ranging from −0.05 to +0.06 mg/m 3 and standard deviations of the differences ranging from 0.36% to 2.08%, supporting the system’s suitability for real‐time monitoring while also enabling the identification of concentration levels approaching occupational exposure thresholds, highlighting its relevance for occupational exposure monitoring in clinical settings. The total system cost remained below 60 USD, enabling scalable deployment in settings with limited technical infrastructure. The results support the clinical applicability of embedded formaldehyde‐sensing technologies as accessible tools for occupational safety in low‐resource healthcare environments.
Zitieren
APA
Castillo, M., Lescher, A., Cerón, M., Ibarra, E., & Molino, J. (2026). Development and Validation of a Low‐Cost IoT Electrochemical Formaldehyde Monitoring System for Clinical Indoor Environments. Journal of Sensors, 2026(1). https://doi.org/10.1155/js/6412281
Vancouver
Castillo M, Lescher A, Cerón M, Ibarra E, Molino J. Development and Validation of a Low‐Cost IoT Electrochemical Formaldehyde Monitoring System for Clinical Indoor Environments. Journal of Sensors. 2026;2026(1). doi:10.1155/js/6412281
BibTeX
@article{Castillo2026,
author = {Castillo, Maria and Lescher, Alfredo and Cerón, Manuel and Ibarra, Ernesto and Molino, Jay},
title = {Development and Validation of a Low‐Cost IoT Electrochemical Formaldehyde Monitoring System for Clinical Indoor Environments},
journal = {Journal of Sensors},
year = {2026},
volume = {2026},
number = {1},
doi = {10.1155/js/6412281}
}
EUVIMED