Optimization of FDM Parameters for Tensile Performance of PLA/MoS 2 Composites
Advances in Polymer Technology · 2026-01 · 2026 (1)
DOI: 10.1155/adv/5895392 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advances in Polymer Technology, online erschienen am 10.11.2026. Verfasst von S. Prathap Singh und 5 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The reinforced biodegradable polymers allow for sustainable and mechanically sound material extrusion components. In this study, a polylactic acid (PLA) composite filament with 5 wt.% molybdenum disulfide (MoS 2 ) was produced by melt extrusion, and the tensile specimens were produced by fused deposition modeling (FDM). The novelty lies in systematically studying the influence of material deposition rate (40–60 mm/s), internal packing density (60%–100%), and internal structural pattern on the tensile strength of the PLA/MoS 2 composite; a Taguchi L9 orthogonal array was used. The tensile strength was measured, ranging from 22.86 to 34.28 MPa. The best build control variable set was determined as a 40 mm/s deposition rate, 100% internal packing density, and a cubic internal structural pattern. Analysis of variance (ANOVA) results revealed that internal packing density has the highest contribution to tensile strength (78.08%), followed by material deposition rate (9.57%) and internal structural pattern (6.99%). An increase in internal packing density showed an increase in material continuity, reduced internal porosity, and better load transfer. The fractography observations showed that the internal voids were smaller and bonding between the layers was better when the internal packing density was higher. Sustainable development goal (SDG): This work supports SDG 12 (responsible consumption and production) through the development of high‐performance biodegradable composite materials for additive manufacturing (AM).
Zitieren
APA
Singh, S. P., Subramaniyan, R., Sindhu, M., Bhowmik, A., Panda, J. K., & Vignesh, P. (2026). Optimization of FDM Parameters for Tensile Performance of PLA/MoS 2 Composites. Advances in Polymer Technology, 2026(1). https://doi.org/10.1155/adv/5895392
Vancouver
Singh SP, Subramaniyan R, Sindhu M, Bhowmik A, Panda JK, Vignesh P. Optimization of FDM Parameters for Tensile Performance of PLA/MoS 2 Composites. Advances in Polymer Technology. 2026;2026(1). doi:10.1155/adv/5895392
BibTeX
@article{Singh2026,
author = {Singh, S. Prathap and Subramaniyan, Ragothaman and Sindhu, M. and Bhowmik, Abhijit and Panda, Jibitesh Kumar and Vignesh, P.},
title = {Optimization of FDM Parameters for Tensile Performance of PLA/MoS 2 Composites},
journal = {Advances in Polymer Technology},
year = {2026},
volume = {2026},
number = {1},
doi = {10.1155/adv/5895392}
}
EUVIMED