EUVIMEDEUVIMED entdecken
Open Access · CC BY 3.0

Mistuning Identification and Model Updating of an Industrial Blisk

D. Laxalde, F. Thouverez, J.-J. Sinou, J.-P. Lombard, S. Baumhauer

International Journal of Rotating Machinery · 2007 · 2007 · 1-10

DOI: 10.1155/2007/17289 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Rotating Machinery, 2007. Verfasst von D. Laxalde und 4 weiteren Autor:innen. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 21 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 3.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The results of a complete study of mistuning identification on an industrial blisk are presented. The identification method used here is based on a model-updating technique of a reduced order. This reduced-order model is built using component mode synthesis, and mistuning is introduced as perturbations of the cantilevered-blade modes. The measured modal data are extracted from global measurements of the blisk's forced response. As we use a single point excitation, this measurement procedure allows the acquisition of all the modes of a given family with a quite simple experimental set-up. A selection of the best identified modal data is finally performed. During the mistuning identification procedure, these measured data are regularized using an eigenvector assignment technique which reduces the influence of eventual measurement errors. An inverse problem, based on the perturbed (mistuned) modal equation, is defined with measured modes as input and mistuning parameters as unknown. Then, the reduced-order model is updated with the identified mistuning, we first perform a correlation on modal responses (using eigenfrequency deviation criteria and MACs). Finally, correlation results on forced responses are presented and discussed.

Zitieren

APA

Laxalde, D., Thouverez, F., Sinou, J., Lombard, J., & Baumhauer, S. (2007). Mistuning Identification and Model Updating of an Industrial Blisk. International Journal of Rotating Machinery, 2007, 1-10. https://doi.org/10.1155/2007/17289

Vancouver

Laxalde D, Thouverez F, Sinou J, Lombard J, Baumhauer S. Mistuning Identification and Model Updating of an Industrial Blisk. International Journal of Rotating Machinery. 2007;2007:1-10. doi:10.1155/2007/17289

BibTeX
@article{Laxalde2007,
  author = {Laxalde, D. and Thouverez, F. and Sinou, J.-J. and Lombard, J.-P. and Baumhauer, S.},
  title = {Mistuning Identification and Model Updating of an Industrial Blisk},
  journal = {International Journal of Rotating Machinery},
  year = {2007},
  volume = {2007},
  pages = {1--10},
  doi = {10.1155/2007/17289}
}
Kostenlos starten →