EUVIMEDEUVIMED entdecken
Crossref

Composition Engineering and Structured Design of Silicon Carbon Composite Anode Materials for High Energy Density Batteries

Jinsuk Lee, Seungin Hwang, Haeun Cho, Haneul Kim, Seungryeol Bae, Sihyun Lee, Youngho Woo, Hanyong Lee, Yongseon Kim

ECS Meeting Abstracts · 07.07.2026 · MA2026-01 (4) · 559-559

DOI: 10.1149/ma2026-014559mtgabs ↗

Kurz gefasst

Fachartikel in der Zeitschrift ECS Meeting Abstracts, erschienen am 07.07.2026. Verfasst von Jinsuk Lee und 8 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Silicon (Si) is an anticipated battery material thanks to its amazing capacity potential compared to the current graphite anode. However, the explosive volume changes during the lithiation and delithiation process remain as a major challenge as delamination of the electrode, structural collapse of composites, loss of conductive contacts, growth of solid-electrolyte interface, which cause a severely decreased capacity over cycles. There are numerous nanostructured Si-based materials with exceptional performance have been reported in the past 20 years, the commercial implementation of high-energy Si-based batteries has been hindered by the bias between industrial application with gravimetrical energy shortages and scientific research with volumetric limits. We have investigated the structured design of silicon carbon composite anode materials and composition engineering of silicon and carbon material’s characterization, which affect electrochemical performance. First, in terms of structural design, embedding Si particles within a carbon framework, NanoMollisAdams (NMA C-Si), is a promising structure to mitigate stress induced by Si expansion and maintain electrode integrity and the pore volume and size of pores of carbon framework affects the electrochemical performance and structural stability. To encapsulate the silicon nanoparticles in the carbon and the carbon pores that provide a buffer for its expansion and reduce the stress to maintain integrity. To achieve high packing density electrode by calendaring process, the larger pore volume has poor structural stability due to its fragility, the smaller pore volume is negative to realizing long cycle life and high rate performance. Embedding Si particles within a porous carbon framework (porous C-Si) has similar structure to mitigate stress. The larger pore volume may fail to fully propagate silicon within its pores and cause reduction in cycle life, the smaller pore volume limits the amount of silicon able to be inserted within the porous carbon framework and reduces the potential capacity. Porous carbon could be in the range of BET in 1700-2000 m 2 /g, pore volume of 0.75-0.9 ml/g, and average pore diameter of 1.60-1.75 nm. Second, in silicon composition engineering, the higher the purity of Si results in a naturally higher crystallinity status. We investigate the range of different crystallinity of silicon particles and find its crystallinity is determined the electrochemical performance in terms of initial capacitance, capacity retention causing by resistance changes, and columbic efficiency. NMA C-Si can use a wide range of silicon crystallinity thanks to simple and relatively low processing cost. NMA C-Si has the advantage of being able to make better anode materials with high crystallinity ingredients. Porous C-Si can only able to use amorphous silicon within the manufacturing process because the precursor is silane(SiH 4 ) gas is amorphous by nature, which results in relatively high production cost and difficult to control process. It is inevitable that silicon can be formed on the surface of porous carbon and can generate the issue of silicon expansion and following SEI layer growth resulting in capacity decrease over cycles. Third, in carbon composition engineering, the higher graphitic carbon has naturally higher crystallinity. The carbon framework, NMA(NanoMollisAdams) is a nanoparticle that has high purity amorphous carbon with a good electrical conductivity and self-assembled isotropic structure. It has strong network with silicon nanoparticles and forming hard coating layer. However, the porous carbon C-Si material made from pitch precursor and low purity and less graphitic interlayer that has lower capacity. NMA shows high Li + diffusion coefficient exceeding 100 × 10⁻⁸ cm² s⁻¹, comparing to pitch-based carbon materials have 10× 10⁻⁸ cm² s⁻¹ and graphite’s 20 × 10⁻⁸ cm² s⁻¹. The homogeneous dispersion of silicon nanoparticles establishes continuous electronic pathways and significantly shortened Li⁺ diffusion lengths, thereby promoting uniform lithiation throughout the entire Si particles and enabling efficient utilization of silicon capacity. Measured with Raman spectroscopy, the R value of NMA carbon is 0.81 and the R value of porous carbon is 1.14. Finally, silicon embedded in NMA carbon framework structure shows less electrode expansion and electrical impedance changes, higher columbic efficiency and capacity retention. Incorporating graphite as a buffer can also alleviate stress on dual carbon layer composite and improves electrode density. This study has achieved high energy density anode electrode demonstrating an ICE of 90%, retention 80% at 500cycles and initial capacity over 600mAh g -1 according to silicon crystallinity and silicon carbon composite composition with graphite mixture. Furthermore, it provides valuable insights into the electrode design of Si/C composites anode materials and graphite by analyzing experimental data and computational analysis. This work was supported by the Technology Development Program (TIPS, RS-2023-00304532) funded by the Ministry of SMEs and Startups (MSS, Korea). Figure 1

Zitieren

APA

Lee, J., Hwang, S., Cho, H., Kim, H., Bae, S., Lee, S., Woo, Y., Lee, H., & Kim, Y. (2026). Composition Engineering and Structured Design of Silicon Carbon Composite Anode Materials for High Energy Density Batteries. ECS Meeting Abstracts, MA2026-01(4), 559-559. https://doi.org/10.1149/ma2026-014559mtgabs

Vancouver

Lee J, Hwang S, Cho H, Kim H, Bae S, Lee S, et al. Composition Engineering and Structured Design of Silicon Carbon Composite Anode Materials for High Energy Density Batteries. ECS Meeting Abstracts. 2026;MA2026-01(4):559-559. doi:10.1149/ma2026-014559mtgabs

BibTeX
@article{Lee2026,
  author = {Lee, Jinsuk and Hwang, Seungin and Cho, Haeun and Kim, Haneul and Bae, Seungryeol and Lee, Sihyun and Woo, Youngho and Lee, Hanyong and Kim, Yongseon},
  title = {Composition Engineering and Structured Design of Silicon Carbon Composite Anode Materials for High Energy Density Batteries},
  journal = {ECS Meeting Abstracts},
  year = {2026},
  volume = {MA2026-01},
  number = {4},
  pages = {559--559},
  doi = {10.1149/ma2026-014559mtgabs}
}
Kostenlos starten →