EUVIMEDEUVIMED entdecken
Crossref

Hydrogen Quality Assurance in High Temperature Hydrogen Production

Ville Saarinen, Luukas Kumpunen

ECS Meeting Abstracts · 07.07.2026 · MA2026-01 (42) · 2158-2158

DOI: 10.1149/ma2026-01422158mtgabs ↗

Kurz gefasst

Fachartikel in der Zeitschrift ECS Meeting Abstracts, erschienen am 07.07.2026. Verfasst von Ville Saarinen und 1 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Today’s global hydrogen economy is growing, driven by the energy transition and decarbonization goals, and its growth is expected to accelerate strongly after 2030. This growth is being driven by government support mechanisms, technological developments, and a large number of new infrastructure projects related to hydrogen storage, pipelines and refuelling stations. However, there are currently no globally binding regulations on hydrogen quality and different purity requirements, which can lead to e.g. expensive re-purification needs at application sites. Depending on the hydrogen production method, purity levels of 98%, 99.5% and 99.97% are typically mentioned, with 99.5% purity generally considered to offer the best balance between technical feasibility and cost-effectiveness for the wider hydrogen production system and value chain. Demanding applications such as fuel cells and sensitive chemical applications still require a hydrogen purity of at least 99.97% according to the ISO 14687 (Hydrogen fuel quality) standard, which is particularly the case for hydrogen-powered mobile applications. VTT has developed a 10 kW reversible high-temperature solid oxide electrolysis system (rSOC) that utilizes novel technical solutions (e.g. superheaters, insulation, heat recovery/utilization methods, etc.) for both co-electrolysis and steam electrolysis. The produced hydrogen can be pressurized to 350 bar for storage. Since the same electrolyzer-compressor system combination is used alternately for both synthesis gas and high-purity hydrogen production, highly accurate system control methods and an efficient hydrogen quality monitoring system have been developed. The aim of the research has been to investigate how low hydrogen impurity concentrations can be detected using optimized SoA gas chromatography technology, especially those that can arise in high temperature hydrogen production, e.g. from the electrolysis process or system components. A commercial gas chromatograph has been reconfigured to analyze the most relevant hydrogen impurities: carbon dioxide, argon, oxygen, nitrogen, carbon monoxide, and methane. Especially important was to determine the lowest possible detection limits compared to the maximum levels specified in the ISO 14687 standard for the following impurities: O 2 (< 5 ppm), H 2 O (< 5 ppm), CO (< 0.2 ppm), CO 2 (< 5 ppm) and N 2 (< 300 ppm). The impurities were detected using sensitive gas chromatograph (GC) equipped with multiple detectors: TCD (Thermal Conductivity Detector), FID (Flame Ionization Detector) and PD-HID (Pulsed Discharge Helium Ionization Detector). The PD-HID detector was capable of high accuracies, up to 100 times the sensitivity of TCDs and about twice the sensitivity of FIDs. By combining these detectors with optimized valve control and column switching, it was possible to characterize the entire impurity profile of the hydrogen stream. The above-mentioned trace impurities can be determined down to 100 ppb level, while TCD and FID detectors provide reliable measurement accuracy in higher concentration ranges where the PD-HID detector would saturate. Based on the validation results, the repeatability and linearity of impurity measurements were excellent and all desired hydrogen impurities could be determined with high measurement accuracy.

Zitieren

APA

Saarinen, V., & Kumpunen, L. (2026). Hydrogen Quality Assurance in High Temperature Hydrogen Production. ECS Meeting Abstracts, MA2026-01(42), 2158-2158. https://doi.org/10.1149/ma2026-01422158mtgabs

Vancouver

Saarinen V, Kumpunen L. Hydrogen Quality Assurance in High Temperature Hydrogen Production. ECS Meeting Abstracts. 2026;MA2026-01(42):2158-2158. doi:10.1149/ma2026-01422158mtgabs

BibTeX
@article{Saarinen2026,
  author = {Saarinen, Ville and Kumpunen, Luukas},
  title = {Hydrogen Quality Assurance in High Temperature Hydrogen Production},
  journal = {ECS Meeting Abstracts},
  year = {2026},
  volume = {MA2026-01},
  number = {42},
  pages = {2158--2158},
  doi = {10.1149/ma2026-01422158mtgabs}
}
Kostenlos starten →