(Invited) High-Temperature Indirectly Heated Solar Receiver–Reactor System for Thermochemical H 2 Production
ECS Meeting Abstracts · 07.07.2026 · MA2026-01 (42) · 2144-2144
DOI: 10.1149/ma2026-01422144mtgabs ↗Kurz gefasst
Fachartikel in der Zeitschrift ECS Meeting Abstracts, erschienen am 07.07.2026. Verfasst von Durgesh Ranjan und 6 weiteren Autor:innen.
Abstract (Originalsprache)
Concentrated solar power can thermally drive redox reactions to produce precursors such as H₂ and CO, which can then be upgraded to synthetic fuels for decarbonizing carbon-intensive sectors including iron and steel, cement, heavy transport, and aviation. Two-step metal oxide redox cycles using an oxygen intermediate (OI) have emerged as a promising approach for such solar thermochemical (STCH) fuel production, typically implemented in directly illuminated receiver–reactor (DIR) systems where a single cavity functions as both solar receiver and redox reactor. In these configurations, the OI placed within the cavity is directly exposed to concentrated solar flux through a transparent window, which often leads to large temperature gradients within OI, reduced material utilization resulting in efficiency penalties in fuel production. To address these limitations, indirectly heated reactors (IdHRs) offer an alternative approach in which solar energy is first absorbed in a solar receiver and then transferred to the redox material by a heat transfer fluid (HTF). In this study, Ga-doped LSM oxygen intermediate was synthesized in a dual-porosity reticulated porous foam and its redox performance was characterized in a vertical tube furnace across a range of temperatures and steam flow rates. Reduction and oxidation rates were quantified to construct a response map that identifies an operating window balancing peak H₂ production rate with overall conversion efficiency. 100 consecutive redox cycles were performed to confirm structural stability with only ~7% loss in H₂ yield over the test campaign. To evaluate performance under indirect heating, an IdHR prototype was designed and coupled to a 5 kW solar receiver, where steam serves as the HTF to deliver the heat required for the redox reactions. The 5-kW solar receiver is a propriety technology, fabricated and supplied by Synhelion. The receiver testing demonstrated steam outlet temperatures approaching 1400 °C under solar simulator operation, providing the high-temperature needed to drive the reduction step in the IdHR. The shell-and-tube heat exchanger inspired design of the IdHR was obtained using numerical heat transfer simulations based on maximizing average volumetric temperature ( T avg ) of the porous OI foam during reduction while maintaining practical reactor aspect ratios at fixed OI mass loading. Simulations were conducted in ANSYS Fluent, coupling fluid flow and heat transfer (conduction and convection) with a Discrete Ordinates radiation model, and treating the reduction reaction as a volumetric heat sink, assuming uniform oxygen partial pressure within the OI. Parametric studies on foam aspect ratio (AR) showed that higher ARs result in increased T avg and simultaneously reduced radial and axial temperature gradients, thereby improving effective material utilization. OI foam with AR = 10 achieved approximately 25% higher reduction non-stoichiometry relative to a foam with AR = 1.25 under otherwise identical conditions. Additional simulations were conducted to quantified the reactor length required to preheat the inert sweep gas and the insulation thickness needed to mitigate external heat losses. Overall, this work provides a design framework for indirectly heated STCH reactors, offers guidelines for integrating them with existing high-temperature solar receiver technology, and delineates pathways for scaling up solar-driven fuel production systems. Figure 1
Zitieren
APA
Ranjan, D., Gadge, Y., Munoz, M., Patil, V., Schoeb, D., Ackermann, S., & Scheffe, J. (2026). (Invited) High-Temperature Indirectly Heated Solar Receiver–Reactor System for Thermochemical H 2 Production. ECS Meeting Abstracts, MA2026-01(42), 2144-2144. https://doi.org/10.1149/ma2026-01422144mtgabs
Vancouver
Ranjan D, Gadge Y, Munoz M, Patil V, Schoeb D, Ackermann S, et al. (Invited) High-Temperature Indirectly Heated Solar Receiver–Reactor System for Thermochemical H 2 Production. ECS Meeting Abstracts. 2026;MA2026-01(42):2144-2144. doi:10.1149/ma2026-01422144mtgabs
BibTeX
@article{Ranjan2026,
author = {Ranjan, Durgesh and Gadge, Yogesh and Munoz, Mario and Patil, Vikas and Schoeb, Damian and Ackermann, Simon and Scheffe, Jonathan},
title = {(Invited) High-Temperature Indirectly Heated Solar Receiver–Reactor System for Thermochemical H 2 Production},
journal = {ECS Meeting Abstracts},
year = {2026},
volume = {MA2026-01},
number = {42},
pages = {2144--2144},
doi = {10.1149/ma2026-01422144mtgabs}
}
EUVIMED