Surface Modification of Li- and Ni-Rich Single-Crystalline Cathode Active Materials for Li-Ion Batteries
ECS Meeting Abstracts · 07.07.2026 · MA2026-01 (3) · 368-368
DOI: 10.1149/ma2026-013368mtgabs ↗Kurz gefasst
Fachartikel in der Zeitschrift ECS Meeting Abstracts, erschienen am 07.07.2026. Verfasst von Tim Kipfer und 3 weiteren Autor:innen.
Abstract (Originalsprache)
In recent years, Li-rich (LR) layered nickel cobalt manganese oxides (NCMs) with the general composition Li 1+ δ TM 1- δ O 2 (0.1 ≤ δ ≤ 0.2, TM = Ni, Co, Mn) have gained increasing attention as an alternative to the already well-established Ni-rich NCMs (with δ ≈ 0) used as cathode active materials (CAMs) for Li-ion batteries. Major advantages of LR-NCMs include their low raw material cost and their high reversible specific capacities of ≈ 250 mAh g -1 , which can be achieved through a combination of cationic and anionic redox. 1–4 However, LR-NCMs still suffer from several drawbacks, such as fast capacity fading and voltage fading, 5,6 as well as an open-circuit-voltage (OCV) hysteresis between charge and discharge, 7–9 which significantly complicates thermal management in large-format cells. 9 In a previous study, 10 we analyzed a matrix of Co-free LR-CAMs with the composition Li 1+ δ [Ni x Mn y ] 1- δ O 2 (with 0.1 ≤ δ ≤ 0.2 and x / y = 0.35/0.65, 0.50/0.50, 0.65/0.35) with respect to the magnitude of the OCV hysteresis expressed through the mean OCV difference between charge and discharge, which defines their intrinsic round-trip energy efficiency. It was found that the amount of reversibly utilized anionic redox scales linearly with the mean OCV difference between charge and discharge and can be reduced by both a decrease in overlithiation δ and an increase in the Ni/Mn ratio, i.e., the ratio x / y , ultimately leading to CAMs with superior energy efficiency. We therefore investigate a Li- and Ni-rich (LNR) CAM with the composition Li 1.10 [Ni 0.65 Mn 0.35 ] 0.90 O 2 in this study and evaluate an approach to increase the CAM/electrolyte interface area to enable faster kinetics through the preparation of a single-crystalline (SC) morphology while subsequently applying a protective surface coating to enable a better long-term cyclability. We systematically investigate the synthetic modification of the SC CAM through the protective coating as a function of annealing temperature by thermogravimetric analysis coupled with mass spectrometry (TGA-MS), powder X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). Finally, we will evaluate the feasibility of the post-treatment approach through electrochemical cycling experiments in LNR-CAM/Li and LNR-CAM/graphite cells. References G. Assat, D. Foix, C. Delacourt, A. Iadecola, R. Dedryvère, and J. M. Tarascon, Nat. Commun. , 8 , 2219 (2017). M. Oishi, C. Yogi, I. Watanabe, T. Ohta, Y. Orikasa, Y. Uchimoto, and Z. Ogumi, J. Power Sources , 276 , 89 (2015). H. Koga, L. Croguennec, M. Ménétrier, P. Mannessiez, F. Weill, C. Delmas, and S. Belin, J. Phys. Chem. C , 118 , 5700 (2014). T. Teufl, B. Strehle, P. Müller, H. A. Gasteiger, and M. A. Mendez, J. Electrochem. Soc. , 165 , A2718 (2018). K. Kleiner, B. Strehle, A. R. Baker, S. J. Day, C. C. Tang, I. Buchberger, F. F. Chesneau, H. A. Gasteiger, and M. Piana, Chem. Mater. , 30 , 3656 (2018). K. G. Gallagher, J. R. Croy, M. Balasubramanian, M. Bettge, D. P. Abraham, A. K. Burrell, and M. M. Thackeray, Electrochem. commun. , 33 , 96 (2013). J. R. Croy, K. G. Gallagher, M. Balasubramanian, B. R. Long, and M. M. Thackeray, J. Electrochem. Soc. , 161 , A318 (2014). J. R. Croy, M. Balasubramanian, K. G. Gallagher, and A. K. Burrell, Acc. Chem. Res. , 48 , 2813 (2015). L. Kraft, T. Zünd, D. Schreiner, R. Wilhelm, F. J. Günter, G. Reinhart, H. A. Gasteiger, and A. Jossen, J. Electrochem. Soc. , 168 , 020537 (2021). T. Kipfer, R. B. Berk, F. Riewald, M. Piana, and H. A. Gasteiger, J. Electrochem. Soc. , 172 , 100505 (2025). Acknowledgement This work is financially supported by BASF SE.
Zitieren
APA
Kipfer, T., Tomuschat, C. R., Wilhelm, R., & Gasteiger, H. A. (2026). Surface Modification of Li- and Ni-Rich Single-Crystalline Cathode Active Materials for Li-Ion Batteries. ECS Meeting Abstracts, MA2026-01(3), 368-368. https://doi.org/10.1149/ma2026-013368mtgabs
Vancouver
Kipfer T, Tomuschat CR, Wilhelm R, Gasteiger HA. Surface Modification of Li- and Ni-Rich Single-Crystalline Cathode Active Materials for Li-Ion Batteries. ECS Meeting Abstracts. 2026;MA2026-01(3):368-368. doi:10.1149/ma2026-013368mtgabs
BibTeX
@article{Kipfer2026,
author = {Kipfer, Tim and Tomuschat, Carlo Robert and Wilhelm, Rebecca and Gasteiger, Hubert Andreas},
title = {Surface Modification of Li- and Ni-Rich Single-Crystalline Cathode Active Materials for Li-Ion Batteries},
journal = {ECS Meeting Abstracts},
year = {2026},
volume = {MA2026-01},
number = {3},
pages = {368--368},
doi = {10.1149/ma2026-013368mtgabs}
}
EUVIMED