EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Balancing Iridium Loading and Catalyst Layer Thickness in TiO x -Based Anodes for Polymer Electrolyte Water Electrolysis

Z. Turtayeva, T. Saillard, J. Herranz, F. N. Büchi

Journal of The Electrochemical Society · 26.06.2026 · 173 (12) · 124501

DOI: 10.1149/1945-7111/ae7837 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of The Electrochemical Society, online erschienen am 17.06.2026. Verfasst von Z. Turtayeva und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Polymer electrolyte water electrolysis (PEWE) is a promising route for sustainable hydrogen production, but its deployment is constrained by the cost and scarcity of iridium-based oxygen evolution reaction (OER) catalysts. Reducing the anode Ir loading while maintaining performance requires careful optimization of the catalyst layer (CL) architecture. In this work, commercial TiO 2 -supported iridium oxide (IrO x ) catalysts with Ir contents ranging from 10 to 75 wt% were systematically evaluated at fixed Ir loadings of 0.5 and 0.1 mg Ir cm −2 . By combining structural characterization, intrinsic electronic conductivity measurements, and electrochemical analysis, correlations between catalyst composition, CL thickness, and electrolysis performance were established. The catalysts with low Ir contents (10 wt%) formed thick, TiO 2 -rich layers associated with limited electronic connectivity, whereas those with high-Ir contents (75 wt%) produced ultrathin layers that, despite improved electronic conductivity, showed reduced effective catalyst utilization and increased sensitivity to structural inhomogeneity. These findings demonstrate that efficient low-Ir anodes require joint optimization of Ir content, catalyst layer thickness, and microstructural connectivity to balance conductive network formation and effective transport pathways. Intermediate-Ir catalysts (30–45 wt%) represent the most practical pathway toward scalable, low-Ir PEMWE electrodes.

Zitieren

APA

Turtayeva, Z., Saillard, T., Herranz, J., & Büchi, F. N. (2026). Balancing Iridium Loading and Catalyst Layer Thickness in TiO x -Based Anodes for Polymer Electrolyte Water Electrolysis. Journal of The Electrochemical Society, 173(12), 124501. https://doi.org/10.1149/1945-7111/ae7837

Vancouver

Turtayeva Z, Saillard T, Herranz J, Büchi FN. Balancing Iridium Loading and Catalyst Layer Thickness in TiO x -Based Anodes for Polymer Electrolyte Water Electrolysis. Journal of The Electrochemical Society. 2026;173(12):124501. doi:10.1149/1945-7111/ae7837

BibTeX
@article{Turtayeva2026,
  author = {Turtayeva, Z. and Saillard, T. and Herranz, J. and Büchi, F. N.},
  title = {Balancing Iridium Loading and Catalyst Layer Thickness in TiO x -Based Anodes for Polymer Electrolyte Water Electrolysis},
  journal = {Journal of The Electrochemical Society},
  year = {2026},
  volume = {173},
  number = {12},
  pages = {124501},
  doi = {10.1149/1945-7111/ae7837}
}
Kostenlos starten →