Preparation and Performance Evaluation of Microporous Transport Layers for Proton Exchange Membrane (PEM) Water Electrolyzer Anodes
Journal of The Electrochemical Society · 01.07.2024 · 171 (7) · 074511
DOI: 10.1149/1945-7111/ad63cf ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of The Electrochemical Society, online erschienen am 31.07.2024. Verfasst von Matthias F. Ernst und 3 weiteren Autor:innen. Die Arbeit wurde bisher 57-mal zitiert (Crossref) und nennt 73 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: German Federal Ministry of Education and Research.
Abstract (Originalsprache)
In this work, ≈25 μm thin titanium microporous layers (MPLs) with ≈2 μm small pores and low surface roughness were coated and sintered on top of ≈260 μm thick commercial titanium-powder-sinter sheets with ≈16 μm pores, maintaining a porosity of ≈40% in both layers. Serving as porous transport layers (PTLs) on the anode side in proton exchange membrane water electrolyzers (PEMWEs), these pore-graded, two-layer sheets (“PTL/MPL”) are compared to single-layer PTLs in single-cell PEMWEs. The PTL/MPL samples prepared here give a 3–6 mΩ cm 2 lower high-frequency resistance (HFR) compared to the as-received single-layer PTL, which is attributed to a partial reduction of the TiO 2 surface passivation layer during the MPL sintering process. For ≈1 μm thin anodes with an iridium loading of ≈0.2 mg Ir cm −2 , the use of an MPL leads to a ≈24 mV improvement in HFR-free cell voltage at 6 A cm −2 . As no such benefit is observed for ≈9 μm thick anodes with ≈2.0 mg Ir cm −2 , mass transport resistances within the PTL/MPL play a minor role. Possible reasons for the higher catalyst utilization in ultra-thin electrodes when using an MPL are discussed. Furthermore, an MPL provides superior mechanical membrane support, which is particularly relevant for thin membranes.
Förderung
- German Federal Ministry of Education and Research
Zitieren
APA
Ernst, M. F., Meier, V., Kornherr, M., & Gasteiger, H. A. (2024). Preparation and Performance Evaluation of Microporous Transport Layers for Proton Exchange Membrane (PEM) Water Electrolyzer Anodes. Journal of The Electrochemical Society, 171(7), 074511. https://doi.org/10.1149/1945-7111/ad63cf
Vancouver
Ernst MF, Meier V, Kornherr M, Gasteiger HA. Preparation and Performance Evaluation of Microporous Transport Layers for Proton Exchange Membrane (PEM) Water Electrolyzer Anodes. Journal of The Electrochemical Society. 2024;171(7):074511. doi:10.1149/1945-7111/ad63cf
BibTeX
@article{Ernst2024,
author = {Ernst, Matthias F. and Meier, Vivian and Kornherr, Matthias and Gasteiger, Hubert A.},
title = {Preparation and Performance Evaluation of Microporous Transport Layers for Proton Exchange Membrane (PEM) Water Electrolyzer Anodes},
journal = {Journal of The Electrochemical Society},
year = {2024},
volume = {171},
number = {7},
pages = {074511},
doi = {10.1149/1945-7111/ad63cf}
}
EUVIMED