EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Impact of Platinum Loading and Layer Thickness on Cathode Catalyst Degradation in PEM Fuel Cells

Patrick Schneider, Mariah Batool, Andres O. Godoy, Rajveer Singh, Dietmar Gerteisen, Jasna Jankovic, Nada Zamel

Journal of The Electrochemical Society · 01.02.2023 · 170 (2) · 024506

DOI: 10.1149/1945-7111/acb8df ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of The Electrochemical Society, online erschienen am 14.02.2023. Verfasst von Patrick Schneider und 6 weiteren Autor:innen. Die Arbeit wurde bisher 75-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science Foundation: PFI-RP award, Bundesministerium für Verkehr und Digitale Infrastruktur, Bundesministerium für Bildung und Forschung.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work we investigate the effect of platinum loading and layer thickness on cathode catalyst degradation by a comprehensive in situ and STEM-EDS characterization. To decouple the effect of the platinum loading and layer thickness from each other, the experiments were categorized in two sets, each with cathode loadings varying between 0.1 and 0.4 mg Pt cm −2 : (i) Samples with a constant Pt/C ratio and thus varying layer thickness, and (ii) samples with varying Pt/C ratios, achieved by dilution with bare carbon, to maintain a constant layer thickness at different platinum loadings. Every MEA was subjected to an accelerated stress test, where the cell was operated for 45,000 cycles between 0.6 and 0.95 V. Regardless of the Pt/C ratio, a higher relative loss in electrochemically active surface area was measured for lower Pt loadings. STEM-EDS measurements showed that Pt was mainly lost close to the cathode—membrane interface by the concentration driven Pt 2+ ion flux into the membrane. The size of this Pt-depletion zone has shown to be independent on the overall Pt loading and layer thickness, hence causing higher relative Pt loss in low thickness electrodes, as the depletion zone accounts for a larger fraction of the catalyst layer.

Förderung

  • National Science Foundation: PFI-RP award
  • Bundesministerium für Verkehr und Digitale Infrastruktur
  • Bundesministerium für Bildung und Forschung

Zitieren

APA

Schneider, P., Batool, M., Godoy, A. O., Singh, R., Gerteisen, D., Jankovic, J., & Zamel, N. (2023). Impact of Platinum Loading and Layer Thickness on Cathode Catalyst Degradation in PEM Fuel Cells. Journal of The Electrochemical Society, 170(2), 024506. https://doi.org/10.1149/1945-7111/acb8df

Vancouver

Schneider P, Batool M, Godoy AO, Singh R, Gerteisen D, Jankovic J, et al. Impact of Platinum Loading and Layer Thickness on Cathode Catalyst Degradation in PEM Fuel Cells. Journal of The Electrochemical Society. 2023;170(2):024506. doi:10.1149/1945-7111/acb8df

BibTeX
@article{Schneider2023,
  author = {Schneider, Patrick and Batool, Mariah and Godoy, Andres O. and Singh, Rajveer and Gerteisen, Dietmar and Jankovic, Jasna and Zamel, Nada},
  title = {Impact of Platinum Loading and Layer Thickness on Cathode Catalyst Degradation in PEM Fuel Cells},
  journal = {Journal of The Electrochemical Society},
  year = {2023},
  volume = {170},
  number = {2},
  pages = {024506},
  doi = {10.1149/1945-7111/acb8df}
}
Kostenlos starten →