Influence of feedstock characteristics and printing parameters on material extrusion additive manufacturing of aluminum-based powder-binder mixtures
Transactions of the Canadian Society for Mechanical Engineering · 01.01.2026 · 50 · 1-10
DOI: 10.1139/tcsme-2025-0245 ↗Kurz gefasst
Fachartikel in der Zeitschrift Transactions of the Canadian Society for Mechanical Engineering, erschienen am 01.01.2026. Verfasst von Gabriel Marcil-St-Onge und 4 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Centre québécois de recherche et de développement de l'aluminium, National Research Council Canada.
Abstract (Originalsprache)
Aluminum and its alloys are widely used in industrial fields such as aerospace and automotive due to their excellent rigidity-to-weight ratio. However, the oxide layer that forms on the surface of aluminum poses challenges for powder metallurgy processes, particularly during sintering. Material extrusion additive manufacturing, a powder-binder-based process, offers advantages of rapid prototyping and low cost but remains largely unexplored for aluminum systems. This study investigates each step of the material extrusion process for AlSi10Mg powders. Feedstocks formulated with 65 vol.% of powder, 25–27 vol.% of paraffin wax, 2 vol.% of stearic acid, and 6–8 vol.% of ethylene–vinyl acetate were printed to produce simple and complex geometries. It was established that the particle size distribution is a critical parameter driving the feedstock behavior and stabilizing its printability. Printed parts underwent thermal wick-debinding at 250 °C for 2 h under argon followed by liquid-phase sintering varying from 565 to 575 °C for 2 h in a nitrogen atmosphere, using sacrificial magnesium granules as an oxygen getter. The sintered parts reached a relative density up to 98% and exhibited an adequate microstructure. However, further optimization is required to mitigate warping during sintering and improve dimensional stability.
Förderung
- Centre québécois de recherche et de développement de l'aluminium
- National Research Council Canada
Zitieren
APA
Marcil-St-Onge, G., Chandoul, A., Pelletier, R., Kreitcberg, A., & Demers, V. (2026). Influence of feedstock characteristics and printing parameters on material extrusion additive manufacturing of aluminum-based powder-binder mixtures. Transactions of the Canadian Society for Mechanical Engineering, 50, 1-10. https://doi.org/10.1139/tcsme-2025-0245
Vancouver
Marcil-St-Onge G, Chandoul A, Pelletier R, Kreitcberg A, Demers V. Influence of feedstock characteristics and printing parameters on material extrusion additive manufacturing of aluminum-based powder-binder mixtures. Transactions of the Canadian Society for Mechanical Engineering. 2026;50:1-10. doi:10.1139/tcsme-2025-0245
BibTeX
@article{MarcilStOnge2026,
author = {Marcil-St-Onge, Gabriel and Chandoul, Abdelberi and Pelletier, Roger and Kreitcberg, Alena and Demers, Vincent},
title = {Influence of feedstock characteristics and printing parameters on material extrusion additive manufacturing of aluminum-based powder-binder mixtures},
journal = {Transactions of the Canadian Society for Mechanical Engineering},
year = {2026},
volume = {50},
pages = {1--10},
doi = {10.1139/tcsme-2025-0245}
}
EUVIMED