EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Design of the NewAthena X-IFU thermal filter demonstration models for the technology readiness assessment: polyimide thickness investigation by transmission spectroscopy

Luisa Sciortino, Michela Todaro, Caterina Tortorici, Ugo Lo Cicero, Fabio D’Anca, Salvatore Varisco, Claudio Saitta, Alberto Gulizzi, Marco Barbera

Journal of Astronomical Telescopes, Instruments, and Systems · 20.11.2026 · 12 (04) · 1-8

DOI: 10.1117/1.jatis.12.4.046003 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Astronomical Telescopes, Instruments, and Systems, erschienen am 20.11.2026. Verfasst von Luisa Sciortino und 8 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Agenzia Spaziale Italiana, Synchrotron soleil.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The baseline design of the thermal filters of the X-Ray Integral Field Unit instrument on board NewAthena consists of ultra-thin films of polyimide and aluminum. These filters shield the detector from out-of-band radiation while maintaining high detector efficiency in the soft X-ray regime. In this paper, we present the measured transmission curves of different polyimide/aluminum filters with differing polyimide thicknesses across the X-ray to far-infrared spectral regions. We also compare the derived X-ray transmission of different combinations of polyimide thicknesses that may compose the stack. Our data show that: (i) the out-of-band rejection of a single filter is independent of polyimide thickness; (ii) the out-of-band rejection, nominally achieved with 30 nm of aluminum per filter, shows some variability that is likely due to aluminum coating defects; and (iii) under the hypothesis of a nominal 30 nm Al thickness per filter, a total polyimide thickness below 300 nm for the full stack complies with the in-band response requirements. Finally, the transmission spectroscopy test campaigns performed and the measurement procedures developed here pave the way for the future calibration program of the X-IFU thermal filters.

Förderung

  • Agenzia Spaziale Italiana
  • Synchrotron soleil

Zitieren

APA

Sciortino, L., Todaro, M., Tortorici, C., Cicero, U. L., D’Anca, F., Varisco, S., Saitta, C., Gulizzi, A., & Barbera, M. (2026). Design of the NewAthena X-IFU thermal filter demonstration models for the technology readiness assessment: polyimide thickness investigation by transmission spectroscopy. Journal of Astronomical Telescopes, Instruments, and Systems, 12(04), 1-8. https://doi.org/10.1117/1.jatis.12.4.046003

Vancouver

Sciortino L, Todaro M, Tortorici C, Cicero UL, D’Anca F, Varisco S, et al. Design of the NewAthena X-IFU thermal filter demonstration models for the technology readiness assessment: polyimide thickness investigation by transmission spectroscopy. Journal of Astronomical Telescopes, Instruments, and Systems. 2026;12(04):1-8. doi:10.1117/1.jatis.12.4.046003

BibTeX
@article{Sciortino2026,
  author = {Sciortino, Luisa and Todaro, Michela and Tortorici, Caterina and Cicero, Ugo Lo and D’Anca, Fabio and Varisco, Salvatore and Saitta, Claudio and Gulizzi, Alberto and Barbera, Marco},
  title = {Design of the NewAthena X-IFU thermal filter demonstration models for the technology readiness assessment: polyimide thickness investigation by transmission spectroscopy},
  journal = {Journal of Astronomical Telescopes, Instruments, and Systems},
  year = {2026},
  volume = {12},
  number = {04},
  pages = {1--8},
  doi = {10.1117/1.jatis.12.4.046003}
}
Kostenlos starten →