EUVIMEDEUVIMED entdecken
Crossref

Atomic layer controlled electron beam induced etching of molybdenum using sequential O2 and HCl exposures with positive sample voltage

Michael A. Collings, Steven M. George

Journal of Vacuum Science & Technology A · 01.12.2026 · 44 (6)

DOI: 10.1116/6.0005676 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Vacuum Science & Technology A, online erschienen am 06.11.2026. Verfasst von Michael A. Collings und 1 weiteren Autor:innen. Die Arbeit nennt 71 Literaturangaben. Gefördert von: Semiconductor Research Corporation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Atomic layer controlled molybdenum (Mo) etching was performed at <100 °C using alternating exposures of O2 and HCl combined with simultaneous electron exposures and positive sample voltage. Electron exposures at ∼100 eV were derived from a hollow cathode plasma electron source. The Mo surface was oxidized to MoOx using concurrent O2 and electron beam exposures. The Mo oxidation rate increased dramatically when a positive voltage of +20 V was applied to the sample stage. Subsequently, the MoOx layer was linearly etched during synchronous HCl and electron exposures when a positive voltage of +20 V was also applied to the sample stage. No enhancement of the oxidation or etching was observed with a negative voltage of −20 V on the sample stage. The oxidation and etching enhancement in the presence of the positive sample voltage suggested that low energy electrons or anions dominated the reaction. The primary electrons at ∼100 eV can produce low energy electrons by ionization of Ar in the reactor and also by secondary electron yield from the Mo substrate. Low energy electrons can form O− or Cl− anions via dissociative electron attachment. Low energy electrons and anions can then be pulled to the sample stage at +20 V. Alternating oxidation and chlorination steps were applied in a digital fashion to define the Mo etching process. An etch per cycle of 1.3 Å/cycle was measured using in situ spectroscopic ellipsometry. The ellipsometric measurements could separately measure the MoOx growth, MoOx removal, and Mo film thickness loss during each etching cycle.

Förderung

  • Semiconductor Research Corporation

Zitieren

APA

Collings, M. A., & George, S. M. (2026). Atomic layer controlled electron beam induced etching of molybdenum using sequential O2 and HCl exposures with positive sample voltage. Journal of Vacuum Science & Technology A, 44(6). https://doi.org/10.1116/6.0005676

Vancouver

Collings MA, George SM. Atomic layer controlled electron beam induced etching of molybdenum using sequential O2 and HCl exposures with positive sample voltage. Journal of Vacuum Science & Technology A. 2026;44(6). doi:10.1116/6.0005676

BibTeX
@article{Collings2026,
  author = {Collings, Michael A. and George, Steven M.},
  title = {Atomic layer controlled electron beam induced etching of molybdenum using sequential O2 and HCl exposures with positive sample voltage},
  journal = {Journal of Vacuum Science & Technology A},
  year = {2026},
  volume = {44},
  number = {6},
  doi = {10.1116/6.0005676}
}
Kostenlos starten →