Multi-Axis Vibration Testing and Strain Analysis of Printed Circuit Boards in Truck Transport
Journal of Electronic Packaging · 01.12.2026 · 148 (4)
DOI: 10.1115/1.4072776 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Electronic Packaging, online erschienen am 11.11.2026. Verfasst von Amin Joodaky und 5 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Gefördert von: Michigan State University.
Abstract (Originalsprache)
Printed circuit boards (PCBs) transported by road are subjected to simultaneous translational and rotational vibration, whereas conventional qualification procedures frequently apply vertical excitation alone. This study presents a repeated-run, within-specimen comparison of vertical-only one-degree-of-freedom (1DOF) excitation and combined vertical–pitch–roll three-degree-of-freedom (3DOF) excitation derived from a measured truck-transport record. The same PCB, fixture, camera arrangement, and single-camera two-dimensional digital image correlation (2D DIC) procedure were used for five runs under each excitation condition. The vertical command and amplitude scaling were retained between protocols, while pitch and roll were added during 3DOF testing; therefore, the protocols were not normalized to equal scalar total-input energy. Dynamic response was quantified using the root-mean-square (RMS) in-plane strain calculated independently for each record of approximately 15 s. At the PCB-surface region, mean RMS strain εx increased from 0.0857 ± 0.0026 % under 1DOF excitation to 0.3810 ± 0.0214 % under 3DOF excitation. The 3DOF value was 4.45 times the 1DOF value, corresponding to a 344.6 % increase. Mean RMS strain εy increased from 0.2742 ± 0.1298 % to 0.5979 ± 0.0645 %. The 3DOF value was 2.18 times the 1DOF value, corresponding to a 118.1 % increase. At the capacitor region, the 3DOF mean RMS values were 2.92 times the corresponding 1DOF values for εx and 1.97 times the corresponding 1DOF values for εy, corresponding to increases of 192.4 % and 96.6 %, respectively. These results show that, for the tested PCB and mounting configuration, the combined 3DOF input produced larger measured in-plane strain than vertical-only excitation. The findings may also inform the development of multi-axis transportation vibration test methods in packaging dynamics beyond electronic products.
Förderung
- Michigan State University
Zitieren
APA
Joodaky, A., Zare, R. N., Sadrabadi, S. A., Jain, M., Safari, M., & Rabbi, F. (2026). Multi-Axis Vibration Testing and Strain Analysis of Printed Circuit Boards in Truck Transport. Journal of Electronic Packaging, 148(4). https://doi.org/10.1115/1.4072776
Vancouver
Joodaky A, Zare RN, Sadrabadi SA, Jain M, Safari M, Rabbi F. Multi-Axis Vibration Testing and Strain Analysis of Printed Circuit Boards in Truck Transport. Journal of Electronic Packaging. 2026;148(4). doi:10.1115/1.4072776
BibTeX
@article{Joodaky2026,
author = {Joodaky, Amin and Zare, Reza Najafi and Sadrabadi, Saeid Ansari and Jain, Mayank and Safari, Mojtaba and Rabbi, Fazle},
title = {Multi-Axis Vibration Testing and Strain Analysis of Printed Circuit Boards in Truck Transport},
journal = {Journal of Electronic Packaging},
year = {2026},
volume = {148},
number = {4},
doi = {10.1115/1.4072776}
}
EUVIMED