EUVIMEDEUVIMED entdecken
Crossref

Production and Characterization of Activated Biochar by Co-Pyrolysis of Delonix regia Biomass and Sodium Hydroxide

Patta Praveen Sai Kumar, Nanda Kishore

Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy · 01.12.2026 · 2 (12)

DOI: 10.1115/1.4072733 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy, online erschienen am 09.10.2026. Verfasst von Patta Praveen Sai Kumar und 1 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Co-pyrolysis of Delonix regia (DR) and sodium hydroxide (NaOH) has been carried out at 600 °C and for 2 h in tubular reactor externally fitted with electric furnace. NaOH in the co-feed was varied from 10 wt% to 30 wt% relative to the mass of DR. Each experiment was repeated thrice to avoid errors, and average results were presented. Biochar was washed with de-ionized water to remove wastes and physically attached sodium from the biochar by ultrasonication for 2 h. Bio-oil was separated into fuel and non-fuel phases using n-hexane, and each separated phase was characterized for its properties. Bio-oil yield was increased with the fraction of NaOH in co-feed, whereas the reverse was true in case of bio-char yield, but the yield of non-condensable gases was unaffected. Bulk and tapped densities of biochar were increased with NaOH, and these values were higher than those of raw DR biomass feed, whereas the reverse was true in case of interparticle packing voidage. The higher heating value of biochar was 23.32 MJ/kg when 10% NaOH was co-fed, and then by further increasing NaOH, it decreased to ≈20 MJ/kg. Energy-dispersive X-ray analysis showed that major fraction of biochar was occupied with carbon (67.2–71.5%), followed by oxygen (15.1–17.1%), and nitrogen (6.4–9.5%), whereas sodium was present very less (1.5–3.5%). X-ray diffraction indicated that biochar crystallite size was large, with 43.33 nm for DR and 10% NaOH co-pyrolysis, and it slightly decreased to 36.62–38.57 nm with further NaOH fraction increment. Brunauer–Emmett–Teller indicated that biochar by pyrolysis of DR alone has the lowest surface area, but that of co-pyrolysis of DR and 10% NaOH has the highest surface area of 53.8 m2/g.

Zitieren

APA

Kumar, P. P. S., & Kishore, N. (2026). Production and Characterization of Activated Biochar by Co-Pyrolysis of Delonix regia Biomass and Sodium Hydroxide. Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy, 2(12). https://doi.org/10.1115/1.4072733

Vancouver

Kumar PPS, Kishore N. Production and Characterization of Activated Biochar by Co-Pyrolysis of Delonix regia Biomass and Sodium Hydroxide. Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy. 2026;2(12). doi:10.1115/1.4072733

BibTeX
@article{Kumar2026,
  author = {Kumar, Patta Praveen Sai and Kishore, Nanda},
  title = {Production and Characterization of Activated Biochar by Co-Pyrolysis of Delonix regia Biomass and Sodium Hydroxide},
  journal = {Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy},
  year = {2026},
  volume = {2},
  number = {12},
  doi = {10.1115/1.4072733}
}
Kostenlos starten →