Optimal Workpiece Placement in a Five-Leg Parallel Machine Tool Based on Force Manipulability
Journal of Mechanisms and Robotics · 01.09.2026 · 18 (9)
DOI: 10.1115/1.4072444 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Mechanisms and Robotics, online erschienen am 14.08.2026. Verfasst von Alessandro Genua und 5 weiteren Autor:innen. Die Arbeit nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This article presents a post-design methodology for optimizing workpiece placement within the predefined workspace of a five degrees-of-freedom parallel kinematic machine tool (PKMT) with SPR–4SPRR architecture. The objective is to identify workpiece locations that improve force-transmission characteristics and reduce actuator effort during machining, without modifying machine geometry or control architecture. The approach combines analytical inverse kinematics, screw-theory-based Jacobian formulation, and force-manipulability analysis to evaluate the force-transmission capability of the machine across the workspace. The workspace is discretized into a dense three-dimensional grid and analyzed for three representative tool tilt angles (0deg, 15deg, and 45deg). A data-driven threshold based on the empirical manipulability distribution is used to retain only well-conditioned configurations, and the optimal workpiece position is defined as the manipulability-weighted centroid of the resulting high-performance region. The method is assessed on an industrial-scale model of the METROM pentapod in matlab simscape through simulated machining trajectories under representative quasi-static cutting loads. Results show that the optimized placement reduces mean peak actuator loads across additional simulated paths by 7.66% at 0deg, 1.36% at 15deg, and 21.22% at 45deg tilt, with corresponding average force reductions of 1.66N, 0.597N, and 5.08N. These findings demonstrate that workspace-aware workpiece placement can enhance the mechanical operating conditions of PKMTs and provide a practical post-deployment strategy for improving machining performance.
Zitieren
APA
Genua, A., Rega, A., Sanseverino, G., Lanzotti, A., Frisoli, A., & Solazzi, M. (2026). Optimal Workpiece Placement in a Five-Leg Parallel Machine Tool Based on Force Manipulability. Journal of Mechanisms and Robotics, 18(9). https://doi.org/10.1115/1.4072444
Vancouver
Genua A, Rega A, Sanseverino G, Lanzotti A, Frisoli A, Solazzi M. Optimal Workpiece Placement in a Five-Leg Parallel Machine Tool Based on Force Manipulability. Journal of Mechanisms and Robotics. 2026;18(9). doi:10.1115/1.4072444
BibTeX
@article{Genua2026,
author = {Genua, Alessandro and Rega, Andrea and Sanseverino, Giuseppe and Lanzotti, Antonio and Frisoli, Antonio and Solazzi, Massimiliano},
title = {Optimal Workpiece Placement in a Five-Leg Parallel Machine Tool Based on Force Manipulability},
journal = {Journal of Mechanisms and Robotics},
year = {2026},
volume = {18},
number = {9},
doi = {10.1115/1.4072444}
}
EUVIMED