Modeling and Optimization of a Multi-Flow Falling Particle Receiver for Generation 3 Concentrating Solar Power
Journal of Solar Energy Engineering · 01.10.2026 · 148 (5)
DOI: 10.1115/1.4072347 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Solar Energy Engineering, online erschienen am 30.07.2026. Verfasst von Ahmed Mohamed und 3 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Gefördert von: Sandia National Laboratories.
Abstract (Originalsprache)
Generation 3 concentrating solar power (CSP) systems use solid particles for heat transfer and thermal energy storage. Particle-based systems can use a falling particle receiver with an open cavity that allows particles to flow together as a curtain. The particle curtain is directly exposed to solar radiation, which is absorbed by the particles as they descend through the receiver. The efficiency of the particle receiver depends on curtain opacity (which is influenced by the mass flowrate of the particles), the average particle temperature, and environmental factors like wind. This research presents a free-falling particle receiver with optimized particle supply management facilitated by ten individually controlled valves. Each valve is equipped with a slide gate and an actuator, ensuring a consistent mass flowrate for a segment of the curtain. In a uniform mass flowrate curtain, the hottest particles accumulate in the center due to non-uniform flux distribution, which leads to higher radiative and advective losses. Accordingly, lower flux levels at the periphery of the curtain result in lower temperature particles. The modular valve design described here improves the solar receiver efficiency and varies the particle curtain opacity in key areas to prevent back wall overheating and improve serviceability. The outer valves have the lowest mass flowrate, while the valves near the center have the highest, allowing for a more uniform heating of the particle curtain. Engineering equation solver is used to analyze the efficiency and performance of the falling particle receiver. The performance of the receiver is optimized by adjusting the mass flowrate in each curtain section. The study aims to determine the ideal mass flowrate for each of the particle curtain valves to augment receiver performance and evaluate back wall temperature under different input flux conditions.
Förderung
- Sandia National Laboratories
Zitieren
APA
Mohamed, A., Mohan, G., Vorobieff, P., & Schroeder, N. (2026). Modeling and Optimization of a Multi-Flow Falling Particle Receiver for Generation 3 Concentrating Solar Power. Journal of Solar Energy Engineering, 148(5). https://doi.org/10.1115/1.4072347
Vancouver
Mohamed A, Mohan G, Vorobieff P, Schroeder N. Modeling and Optimization of a Multi-Flow Falling Particle Receiver for Generation 3 Concentrating Solar Power. Journal of Solar Energy Engineering. 2026;148(5). doi:10.1115/1.4072347
BibTeX
@article{Mohamed2026,
author = {Mohamed, Ahmed and Mohan, Gowtham and Vorobieff, Peter and Schroeder, Nathan},
title = {Modeling and Optimization of a Multi-Flow Falling Particle Receiver for Generation 3 Concentrating Solar Power},
journal = {Journal of Solar Energy Engineering},
year = {2026},
volume = {148},
number = {5},
doi = {10.1115/1.4072347}
}
EUVIMED