EUVIMEDEUVIMED entdecken
Crossref

Design of an Additively-Manufactured Die for Vaporizing Foil Actuator Forming

Jan Bechler, Lukas Dombrowski, Hamed Dardaei Joghan, Marlon Hahn, Yannis P. Korkolis

Journal of Manufacturing Science and Engineering · 01.10.2026 · 148 (10)

DOI: 10.1115/1.4072293 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Manufacturing Science and Engineering, online erschienen am 11.08.2026. Verfasst von Jan Bechler und 4 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben. Gefördert von: Deutsche Forschungsgemeinschaft.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The flexibility of tooling for individual parts produced by the high-speed vaporizing foil actuator forming (VFAF) process is increased by replacing the conventional, solid, geometry-bound die with a flexible, low-cost, thin, form-giving additively-manufactured (AM) polymer die supported by a shear-thickening fluid (STF). During the impact of the workpiece onto the AM die, the STF transitions into a quasi-solid state, providing structural support throughout the forming operation. In this study, the design of the air evacuation system is investigated for the production of cranial implants, as a representative example of highly individualized parts. A numerical model is used to determine the necessary pressure required to fully form the sheet and to gain further process insights into the forming process for individual parts. The experiments show that the position and number of air evacuation channels influence the structural integrity of the AM die. Numerical and physical experiments show that the air evacuation channels should be positioned at an angle to the electrical current flow in the side walls to prevent the formation of the sheet into the channels and failure of the AM die. This positioning of the air evacuation channels allows successful forming of cranial implants with a nominal geometric deviation of ±1 mm, which is comparable to that reported in the literature for other flexible manufacturing processes. The liquid–solid tooling concept represents a promising alternative to conventional solid steel dies, offering significantly reduced tooling costs, time to manufacture, and enhanced adaptability for individualized production.

Förderung

  • Deutsche Forschungsgemeinschaft

Zitieren

APA

Bechler, J., Dombrowski, L., Joghan, H. D., Hahn, M., & Korkolis, Y. P. (2026). Design of an Additively-Manufactured Die for Vaporizing Foil Actuator Forming. Journal of Manufacturing Science and Engineering, 148(10). https://doi.org/10.1115/1.4072293

Vancouver

Bechler J, Dombrowski L, Joghan HD, Hahn M, Korkolis YP. Design of an Additively-Manufactured Die for Vaporizing Foil Actuator Forming. Journal of Manufacturing Science and Engineering. 2026;148(10). doi:10.1115/1.4072293

BibTeX
@article{Bechler2026,
  author = {Bechler, Jan and Dombrowski, Lukas and Joghan, Hamed Dardaei and Hahn, Marlon and Korkolis, Yannis P.},
  title = {Design of an Additively-Manufactured Die for Vaporizing Foil Actuator Forming},
  journal = {Journal of Manufacturing Science and Engineering},
  year = {2026},
  volume = {148},
  number = {10},
  doi = {10.1115/1.4072293}
}
Kostenlos starten →