EUVIMEDEUVIMED entdecken
Crossref

The Combination of Rear Flaps and Plasma Actuators for the Drag Reduction of a Square-Back Bluff Body

Yutaka Kaneko, Shūji Ōtomo, Taisuke Torin, Yusuke Kakuya, Takafumi Saito, Tatsuhiko Hanai, Takashi Matsuno, Hiroyuki Nishida

Journal of Fluids Engineering · 01.12.2025 · 147 (12)

DOI: 10.1115/1.4068762 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Fluids Engineering, online erschienen am 18.06.2025. Verfasst von Yutaka Kaneko und 7 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 65 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

There is a significant need to reduce the aerodynamic drag of ground vehicles. As a result, the active and passive methods of flow control around bluff bodies have been extensively studied to improve aerodynamic performance. In this study, the drag reduction by combining rear flaps and plasma actuators (PAs) is experimentally investigated. PAs are modern active flow control devices that leverage nonthermal plasma, whereas flaps are traditional passive flow control devices. Flaps and PAs are mounted on the square back of the truck model, and the effect of the flap mounting locations (top or side of the model), flap angle, and flap length are investigated at ReH=1.58×105. For both top and side flaps, the longer flaps result in greater drag reduction compared to shorter flaps in the absence of PA actuation. However, additional drag reduction with PA actuation is minimal for the longer flaps, and the flap angle at which drag reaches a local minimum remained unchanged. This is attributed to an increase in pressure drag on the flap as the flap angle increases when the flow is attached to the flap surface. In contrast, PA actuation with shorter flaps demonstrates drag reduction, due to the smaller surface area of the flaps. These results suggest that optimizing the flap angle and length is a promising strategy to maximize the aerodynamic benefits of PA actuation and reduce the drag on bluff bodies.

Zitieren

APA

Kaneko, Y., Ōtomo, S., Torin, T., Kakuya, Y., Saito, T., Hanai, T., Matsuno, T., & Nishida, H. (2025). The Combination of Rear Flaps and Plasma Actuators for the Drag Reduction of a Square-Back Bluff Body. Journal of Fluids Engineering, 147(12). https://doi.org/10.1115/1.4068762

Vancouver

Kaneko Y, Ōtomo S, Torin T, Kakuya Y, Saito T, Hanai T, et al. The Combination of Rear Flaps and Plasma Actuators for the Drag Reduction of a Square-Back Bluff Body. Journal of Fluids Engineering. 2025;147(12). doi:10.1115/1.4068762

BibTeX
@article{Kaneko2025,
  author = {Kaneko, Yutaka and Ōtomo, Shūji and Torin, Taisuke and Kakuya, Yusuke and Saito, Takafumi and Hanai, Tatsuhiko and Matsuno, Takashi and Nishida, Hiroyuki},
  title = {The Combination of Rear Flaps and Plasma Actuators for the Drag Reduction of a Square-Back Bluff Body},
  journal = {Journal of Fluids Engineering},
  year = {2025},
  volume = {147},
  number = {12},
  doi = {10.1115/1.4068762}
}
Kostenlos starten →