Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition
Journal of Turbomachinery · 01.01.2025 · 147 (1)
DOI: 10.1115/1.4066145 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Turbomachinery, online erschienen am 03.09.2024. Verfasst von Haoyang Liu und 4 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 18 Literaturangaben. Gefördert von: National Natural Science Foundation of China.
Abstract (Originalsprache)
The discharge coefficient of laidback fan-shaped holes on turbine blades under internal crossflow conditions is investigated using experimental and numerical simulation methods. The study is conducted on a linear cascade, with single rows of film holes set on both the pressure and suction surfaces of the test blade, coolant supplied by an internal crossflow channel. The internal crossflow Reynolds number ranged from 39,100 to 78,200, and the pressure ratio ranged from 1 to 1.5. This research considered the effects of internal crossflow Reynolds numbers and hole length-to-diameter ratio on the discharge coefficient of laidback fan-shaped holes. The findings are as follows: internal crossflow increases the inlet loss of film holes and flow separation within the holes, leading to a significant reduction in the discharge coefficient of film holes. Meanwhile, film holes on the pressure surface of the blade exhibit greater sensitivity to crossflow. Under different hole length-to-diameter ratio conditions, the length of the cylindrical section is the primary factor affecting the discharge coefficient, and the magnitude of the discharge coefficient depends on the extent of flow separation within the cylindrical section. The sensitivity of the discharge coefficient to variations in the cylindrical section length decreases once the cylindrical section length exceeds 2.8D for the pressure surface and 2.0D for the suction surface, where the inlet separation region reattaches to the wall. Under plenum conditions, there are significant differences in the discharge coefficients of film holes between the suction surface and pressure surface, especially at pressure ratios below 1.05.
Förderung
- National Natural Science Foundation of China
Zitieren
APA
Liu, H., Du, Q., Xu, Q., Li, H., & Xu, G. (2025). Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition. Journal of Turbomachinery, 147(1). https://doi.org/10.1115/1.4066145
Vancouver
Liu H, Du Q, Xu Q, Li H, Xu G. Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition. Journal of Turbomachinery. 2025;147(1). doi:10.1115/1.4066145
BibTeX
@article{Liu2025,
author = {Liu, Haoyang and Du, Qiang and Xu, Qingzong and Li, Hongye and Xu, Guangyao},
title = {Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition},
journal = {Journal of Turbomachinery},
year = {2025},
volume = {147},
number = {1},
doi = {10.1115/1.4066145}
}
EUVIMED