EUVIMEDEUVIMED entdecken
Crossref

Distribution of Residual Stress in Wire-Arc Additively Manufactured Small-Scale Component: Single- Versus Multi-Level Heat Input

Shekhar Srivastava, Rajiv Kumar Garg, Anish Sachdeva, Vishal S. Sharma

Journal of Manufacturing Science and Engineering · 01.02.2023 · 145 (2)

DOI: 10.1115/1.4055569 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Manufacturing Science and Engineering, online erschienen am 30.09.2022. Verfasst von Shekhar Srivastava und 3 weiteren Autor:innen. Die Arbeit wurde bisher 26-mal zitiert (Crossref) und nennt 47 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Accumulated heat input during layer deposition causes high residual stress in the Wire-Arc Additive Manufacturing (WAAM) components. The developed residual stress results in defects like distortion, delamination, cracks, and low fatigue life. To deal with such engineering problems, numerical methods have always been required. It gives an insight into the system that can be used for real-world applications. Consequently, a sequentially coupled finite element model has been developed to simulate the thermal–structural behavior of the feedstock during and after deposition in the WAAM process. Precisely, a novel multi-level layer-wise heat input approach characterized by four different stages is compared with the layer-wise single heat input strategy. The variation of thermal and residual stress distributions has been studied based on the different cases proposed related to layer-wise multi-level heat loading. A good agreement between predicted and experimentally observed temperature and residual stress values has been observed. The developed framework predicted thermal distribution with an average error of 9.71%, 9.13%, 7.57%, and 4.52% for case #1, case #2, case #3, and case #4, respectively. In addition to that, longitudinal stresses in the modeled component recorded a reduction of 17.94% for four-level heat input (case #4) compared to the respective value observed in case #1. Therefore, a multi-level heat input strategy is recommended over a single-level heat input approach for the components with small deposition lengths manufactured through the WAAM process.

Zitieren

APA

Srivastava, S., Garg, R. K., Sachdeva, A., & Sharma, V. S. (2023). Distribution of Residual Stress in Wire-Arc Additively Manufactured Small-Scale Component: Single- Versus Multi-Level Heat Input. Journal of Manufacturing Science and Engineering, 145(2). https://doi.org/10.1115/1.4055569

Vancouver

Srivastava S, Garg RK, Sachdeva A, Sharma VS. Distribution of Residual Stress in Wire-Arc Additively Manufactured Small-Scale Component: Single- Versus Multi-Level Heat Input. Journal of Manufacturing Science and Engineering. 2023;145(2). doi:10.1115/1.4055569

BibTeX
@article{Srivastava2023,
  author = {Srivastava, Shekhar and Garg, Rajiv Kumar and Sachdeva, Anish and Sharma, Vishal S.},
  title = {Distribution of Residual Stress in Wire-Arc Additively Manufactured Small-Scale Component: Single- Versus Multi-Level Heat Input},
  journal = {Journal of Manufacturing Science and Engineering},
  year = {2023},
  volume = {145},
  number = {2},
  doi = {10.1115/1.4055569}
}
Kostenlos starten →