Numerical Study on the Electrohydrodynamic Jet Printing
Journal of Micro and Nano-Manufacturing · 01.03.2021 · 9 (1)
DOI: 10.1115/1.4049820 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Micro and Nano-Manufacturing, online erschienen am 19.02.2021. Verfasst von Xue Yang und 4 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 25 Literaturangaben. Gefördert von: Education Department of Jilin Province, National Natural Science Foundation of China, State Key Laboratory of Geohazard Prevention and Geoenvironment Protection.
Abstract (Originalsprache)
Electrohydrodynamic (EHD) printing is an alternative method to fabricate high-resolution micro- and nanostructures with high efficiency, low cost, and low pollution. Numerical simulation is an effective approach to systematically investigate the formation process of EHD jet. However, there are a few articles performing this work. In this study, a finite element model was established. The jet formation process and jetting modes were analyzed. The influence of applied voltage and printing distance on the maximum electric field near the nozzle tip was investigated. The effect of flow rate on the jet diameters was studied. Comparison between numerical and experimental results demonstrated that the proposed simulation model had a high potential for EHD jet analysis. According to the optimized printing conditions (printing distance of 200–300 μm, applied voltage of ∼1100 V, and flow rate of 0.1–0.3 ml/h), stable EHD jet can generate and polyvinyl pyrrolidone (PVP) lines with minimum line-width of 0.9 μm can be printed onto the glass slide.
Förderung
- Education Department of Jilin Province
- National Natural Science Foundation of China
- State Key Laboratory of Geohazard Prevention and Geoenvironment Protection
Zitieren
APA
Yang, X., Wang, S., Yin, Z., Wang, J., & Hu, W. (2021). Numerical Study on the Electrohydrodynamic Jet Printing. Journal of Micro and Nano-Manufacturing, 9(1). https://doi.org/10.1115/1.4049820
Vancouver
Yang X, Wang S, Yin Z, Wang J, Hu W. Numerical Study on the Electrohydrodynamic Jet Printing. Journal of Micro and Nano-Manufacturing. 2021;9(1). doi:10.1115/1.4049820
BibTeX
@article{Yang2021,
author = {Yang, Xue and Wang, Shuobang and Yin, Zhifu and Wang, Jili and Hu, Wei},
title = {Numerical Study on the Electrohydrodynamic Jet Printing},
journal = {Journal of Micro and Nano-Manufacturing},
year = {2021},
volume = {9},
number = {1},
doi = {10.1115/1.4049820}
}
EUVIMED