EUVIMEDEUVIMED entdecken
Crossref

Micro Flat End Milling Simulation Model With Instantaneous Plowing Area Prediction

Abdolreza Bayesteh, Junghyuk Ko, Martin Byung-Guk Jun

Journal of Micro and Nano-Manufacturing · 01.06.2016 · 4 (2)

DOI: 10.1115/1.4032757 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Micro and Nano-Manufacturing, online erschienen am 23.03.2016. Verfasst von Abdolreza Bayesteh und 2 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 12 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

There is an increasing demand for product miniaturization and parts with features as low as few microns. Micromilling is one of the promising methods to fabricate miniature parts in a wide range of sectors including biomedical, electronic, and aerospace. Due to the large edge radius relative to uncut chip thickness, plowing is a dominant cutting mechanism in micromilling for low feed rates and has adverse effects on the surface quality, and thus, for a given tool path, it is important to be able to predict the amount of plowing. This paper presents a new method to calculate plowing volume for a given tool path in micromilling. For an incremental feed rate movement of a micro end mill along a given tool path, the uncut chip thickness at a given feed rate is determined, and based on the minimum chip thickness value compared to the uncut chip thickness, the areas of plowing and shearing are calculated. The workpiece is represented by a dual-Dexel model, and the simulation properties are initialized with real cutting parameters. During real-time simulation, the plowed volume is calculated using the algorithm developed. The simulated chip area results are qualitatively compared with measured resultant forces for verification of the model and using the model, effects of cutting conditions such as feed rate, edge radius, and radial depth of cut on the amount of shearing and plowing are investigated.

Zitieren

APA

Bayesteh, A., Ko, J., & Jun, M. B. (2016). Micro Flat End Milling Simulation Model With Instantaneous Plowing Area Prediction. Journal of Micro and Nano-Manufacturing, 4(2). https://doi.org/10.1115/1.4032757

Vancouver

Bayesteh A, Ko J, Jun MB. Micro Flat End Milling Simulation Model With Instantaneous Plowing Area Prediction. Journal of Micro and Nano-Manufacturing. 2016;4(2). doi:10.1115/1.4032757

BibTeX
@article{Bayesteh2016,
  author = {Bayesteh, Abdolreza and Ko, Junghyuk and Jun, Martin Byung-Guk},
  title = {Micro Flat End Milling Simulation Model With Instantaneous Plowing Area Prediction},
  journal = {Journal of Micro and Nano-Manufacturing},
  year = {2016},
  volume = {4},
  number = {2},
  doi = {10.1115/1.4032757}
}
Kostenlos starten →