EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Lifting Efficiency of Barbed Sutures for Potential Face Lifting Application: A Parametric Analysis

Chen-Ying Su, Mayur Jiyalal Prajapati, Jia-Rou Lin, Cho-Pei Jiang iD, Hsu-Wei Fang

Journal of Cosmetic Dermatology · 2026-03 · 25 (3)

DOI: 10.1111/jocd.70730 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Cosmetic Dermatology, online erschienen am 06.03.2026. Verfasst von Chen-Ying Su und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical Engineering and Biotechnology, National Taipei University of Technology, Taipei, Taiwan. Hauptthemen laut MEDLINE: Rhytidoplasty, Sutures. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Economic Affairs, Taiwan, Ministry of Economic Affairs.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

Absorbable barbed sutures have been widely used for minimally invasive facial rejuvenation. However, clinical lifting performance varies due to differences in suture geometry, which remain insufficiently quantified.

Objective

The study aims to evaluate the effects of barb rotation angle, barb orientation, and pulling speed on the lifting performance and efficiency of the barbed sutures. The goal is to identify the optimized geometric design for facial lifting applications.

Methods

The barbs were fabricated with four rotation angles (30°, 45°, 90°, and 180°) and four orientations (Forward, Reverse, Forward‐Reverse, and Reverse‐Forward). The fabricated sutures were tested at 10, 50, and 100 mm/min. Maximum lifting and holding displacements and lifting efficiency were quantified. Statistical analysis was conducted using one‐way ANOVA with Tukey's post hoc test ( p < 0.05).

Results

Higher pulling speed increased maximum lift but reduced efficiency due to slippage. The maximum lift was at 100 mm/min (2.03 ± 0.08 mm), whereas the highest lifting efficiency was at 10 mm/min (42.7%). For the barb rotation angles, the 90° configuration showed the highest lifting efficiency (35.5%) and superior anchor stability ( p < 0.05). Regarding the barb orientation, the Forward orientation produced the largest lift (1.72 ± 0.18 mm), while the Forward‐Reverse orientation achieved the highest efficiency (35.5%). The optimized Forward‐Reverse 90° configuration exhibited improved holding capacity and reduced slippage compared to a commercial barbed suture.

Conclusion

Barb geometry critically affects the lifting performance of the suture. The Forward‐Reverse 90° configuration shows the optimal lifting efficiency and stability, offering clinically relevant guidance for designing next‐generation facial lifting sutures.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

RhytidoplastySuturesHumansSuture TechniquesRotationMaterials TestingRejuvenationEquipment Design

Autor:innen und Institutionen

  • Department of Chemical Engineering and Biotechnology, National Taipei University of Technology, Taipei, Taiwan.
  • High-Value Biomaterials Research and Commercialization Center, National Taipei University of Technology, Taipei, Taiwan.
  • Department of Mechanical Engineering, National Taipei University of Technology, Taipei, Taiwan.
  • Institute of Biomedical Engineering and Nanomedicine, National Health Research Institutes, Zhunan Town, Taiwan.
  • Institute of Oral Tissue Engineering and Biomaterials, National Yang Ming Chiao Tung University, Taipei, Taiwan.

ORCID-Profile: Cho-Pei Jiang

Förderung

  • Ministry of Economic Affairs, Taiwan
  • Ministry of Economic Affairs

Zitieren

APA

Su, C. Y., Prajapati, M. J., Lin, J. R., Jiang, C. P., & Fang, H. W. (2026). Lifting Efficiency of Barbed Sutures for Potential Face Lifting Application: A Parametric Analysis. Journal of Cosmetic Dermatology, 25(3). https://doi.org/10.1111/jocd.70730

Vancouver

Su CY, Prajapati MJ, Lin JR, Jiang CP, Fang HW. Lifting Efficiency of Barbed Sutures for Potential Face Lifting Application: A Parametric Analysis. Journal of Cosmetic Dermatology. 2026;25(3). doi:10.1111/jocd.70730

BibTeX
@article{Su2026,
  author = {Su, Chen-Ying and Prajapati, Mayur Jiyalal and Lin, Jia-Rou and Jiang, Cho-Pei and Fang, Hsu-Wei},
  title = {Lifting Efficiency of Barbed Sutures for Potential Face Lifting Application: A Parametric Analysis},
  journal = {Journal of Cosmetic Dermatology},
  year = {2026},
  volume = {25},
  number = {3},
  doi = {10.1111/jocd.70730}
}
Kostenlos starten →