EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Phlogopite Mica Under Acidic and Alkaline Conditions: Reactivity and Silicate Gel Formation

Mahtab Akbarzadeh Khoei, Julson Tchio, Labeed Ahmad, Juho Antti Sirviö, Juho Yliniemi

Journal of the American Ceramic Society · 2026-06 · 109 (6)

DOI: 10.1111/jace.70910 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of the American Ceramic Society, online erschienen am 03.06.2026. Verfasst von Mahtab Akbarzadeh Khoei und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Research Council of Finland.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Alkali‐activated materials (AAMs) produced using industrial residues offer a sustainable alternative to Portland cement, the production of which contributes nearly 8% of global CO 2 emissions. However, commercial sodium silicate, commonly used as an activator, remains costly and energy‐intensive to produce, motivating the development of alternative silicate sources. This study proposes a novel approach for producing alkali activators from phlogopite, a magnesium‐rich mining by‐product, through a combined mechanical activation and acid leaching route. In particular, the use of ultrasonic‐assisted leaching (sonication) is investigated as a non‐conventional method to enhance dissolution and improve activator composition. Phlogopite was milled and subsequently treated with citric acid using either mechanical stirring or sonication. The leached cations (e.g., K and Mg) were identified as potential secondary resources, while the resulting silicate‐rich residue was dissolved in NaOH to synthesize alkali activators. Sonication significantly enhanced the process, yielding an activator with improved silicate content (∼6 wt.% SiO 2 ) and reduced Na 2 O concentration (∼12 wt.%), compared to mechanically treated systems. Incorporating 20 wt.% sonicated phlogopite‐derived activator in blast furnace slag (BFS) resulted in a compressive strength of 40 MPa after 28 days, compared to 22 MPa for the reference, corresponding to an increase of ∼82%. Microstructural analysis revealed denser reaction products and reduced porosity, with the formation of calcium (sodium) aluminosilicate hydrates and layered double hydroxides. These results demonstrate the potential of ultrasonic‐assisted processing of phlogopite can be used to produce effective alkali activators, offering a promising pathway to reduce reliance on commercial sodium silicate and improve the sustainability of AAM systems.

Förderung

  • Research Council of Finland

Zitieren

APA

Khoei, M. A., Tchio, J., Ahmad, L., Sirviö, J. A., & Yliniemi, J. (2026). Phlogopite Mica Under Acidic and Alkaline Conditions: Reactivity and Silicate Gel Formation. Journal of the American Ceramic Society, 109(6). https://doi.org/10.1111/jace.70910

Vancouver

Khoei MA, Tchio J, Ahmad L, Sirviö JA, Yliniemi J. Phlogopite Mica Under Acidic and Alkaline Conditions: Reactivity and Silicate Gel Formation. Journal of the American Ceramic Society. 2026;109(6). doi:10.1111/jace.70910

BibTeX
@article{Khoei2026,
  author = {Khoei, Mahtab Akbarzadeh and Tchio, Julson and Ahmad, Labeed and Sirviö, Juho Antti and Yliniemi, Juho},
  title = {Phlogopite Mica Under Acidic and Alkaline Conditions: Reactivity and Silicate Gel Formation},
  journal = {Journal of the American Ceramic Society},
  year = {2026},
  volume = {109},
  number = {6},
  doi = {10.1111/jace.70910}
}
Kostenlos starten →