EUVIMEDEUVIMED entdecken
Crossref

A Laser‐Laser Method for In Situ C and O Isotope Measurements in Carbonate Materials

Alban Petitjean, Olivier Musset, Pierre Sansjofre, Christophe Thomazo

Geostandards and Geoanalytical Research · 2026-03 · 50 (1) · 97-113

DOI: 10.1111/ggr.70023 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Geostandards and Geoanalytical Research, online erschienen am 20.10.2025. Verfasst von Alban Petitjean und 3 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 29 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A portable device was developed to produce CO 2 through laser‐induced calcination of carbonates that can be paired with a commercial field‐deployable isotope ratio mass spectrometer. This new set‐up allows for direct measurements of carbon (δ 13 C) and oxygen (δ 18 O) isotope ratios of carbonates under field conditions. The set‐up was designed with a pistol‐form handset and backpack for ease of handling by a single operator in the field. We demonstrate how the sampling prototype circumvents the steps of sample collection, grinding, drying and acid digestion by directly producing CO 2 from a raw rock sample in conditions that are representative of fieldwork. The CO 2 evolved using our new device was isotopically measured off‐site, using an isotope‐ratio infrared spectrometer and the results were compared with those from a classical preparation that used acid digestion. Different ways to achieve the necessary threshold of CO 2 concentration for subsequent isotope measurements are discussed. Overall, we demonstrate that this laser portable calcination device allows for isotope measurements after a minimal conversion of 32 mg of carbonate material with an uncertainty at 1 s of 0.41 and 0.68‰ for δ 13 C and δ 18 O, respectively. The comparison with measurements performed after acid digestion shows that the uncertainty in the preparation technique is 0.01 and 0.03‰ for δ 13 C and δ 18 O, respectively. Overall, the laser‐induced calcination portable device offers an avenue for fast, accurate and remote measurements of carbonate isotope ratios, but field specific challenges such as the water content of samples also need to be considered.

Zitieren

APA

Petitjean, A., Musset, O., Sansjofre, P., & Thomazo, C. (2026). A Laser‐Laser Method for In Situ C and O Isotope Measurements in Carbonate Materials. Geostandards and Geoanalytical Research, 50(1), 97-113. https://doi.org/10.1111/ggr.70023

Vancouver

Petitjean A, Musset O, Sansjofre P, Thomazo C. A Laser‐Laser Method for In Situ C and O Isotope Measurements in Carbonate Materials. Geostandards and Geoanalytical Research. 2026;50(1):97-113. doi:10.1111/ggr.70023

BibTeX
@article{Petitjean2026,
  author = {Petitjean, Alban and Musset, Olivier and Sansjofre, Pierre and Thomazo, Christophe},
  title = {A Laser‐Laser Method for In Situ C and O Isotope Measurements in Carbonate Materials},
  journal = {Geostandards and Geoanalytical Research},
  year = {2026},
  volume = {50},
  number = {1},
  pages = {97--113},
  doi = {10.1111/ggr.70023}
}
Kostenlos starten →