Surface wear and roughness of experimental composites containing calcium orthophosphate particles following toothbrush abrasion
European Journal of Oral Sciences · 2026
DOI: 10.1111/eos.70063 ↗Kurz gefasst
Vergleichsstudie in der Zeitschrift European Journal of Oral Sciences, 2026. Verfasst von Handially S Vilela und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Biomaterials and Oral Biology, School of Dentistry, University of São Paulo, São Paulo, Brazil. Hauptthemen laut MEDLINE: Composite Resins, Toothbrushing, Calcium Phosphates. Die Arbeit nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: São Paulo Research Foundation (FAPESP).
Abstract (Originalsprache)
This study evaluated experimental composites containing dicalcium phosphate dihydrate (DCPD) particles for toothbrush wear and roughness. Composites containing bisphenol‐A glycidyl dimethacrylate/triethylene glycol dimethacrylate with 50 vol% inorganic fraction consisting of barium glass and DCPD (35:15 and 15:35 vol%) or barium glass only were tested alongside a commercial composite (Beautifil II, Shofu) and a glass‐ionomer cement (GIC, Fuji Gold Label 9, GC). Surface loss and roughness were quantified after 50,000 and 100,000 cycles using optical profilometry. The specimens were observed under scanning electron microscopy. Data were analyzed by two‐way analysis of variance/Tukey test. After 50,000 cycles, surface loss was higher for the 35% DCPD composite compared to the experimental control and the GIC. After 100,000 cycles, composites with DCPD presented surface loss not different than the commercial composite but higher than seen for the experimental control and the GIC. Roughness for the composite with 35% DCPD was not different than that of the GIC at baseline, which was higher than seen for the other materials. After 100,000 cycles, roughness for the materials containing DCPD and the GIC were not statistically different. In conclusion, the results suggest that DCPD‐containing composites would be better suited for restoration of deciduous teeth and low load‐bearing restorations in permanent teeth.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Biomaterials and Oral Biology, School of Dentistry, University of São Paulo, São Paulo, Brazil.
- Department of Restorative Dentistry, School of Dentistry, University of São Paulo, São Paulo, Brazil.
ORCID-Profile: Handially S Vilela, Mariana C A Resende, Leticia O Sakae, Amanda L Campos, Tais Scaramucci, Roberto R Braga
Förderung
- São Paulo Research Foundation (FAPESP)
Zitieren
APA
Vilela, H. S., Resende, M. C. A., Sakae, L. O., Campos, A. L., Scaramucci, T., & Braga, R. R. (2026). Surface wear and roughness of experimental composites containing calcium orthophosphate particles following toothbrush abrasion. European Journal of Oral Sciences. https://doi.org/10.1111/eos.70063
Vancouver
Vilela HS, Resende MCA, Sakae LO, Campos AL, Scaramucci T, Braga RR. Surface wear and roughness of experimental composites containing calcium orthophosphate particles following toothbrush abrasion. European Journal of Oral Sciences. 2026. doi:10.1111/eos.70063
BibTeX
@article{Vilela2026,
author = {Vilela, Handially S and Resende, Mariana C A and Sakae, Leticia O and Campos, Amanda L and Scaramucci, Tais and Braga, Roberto R},
title = {Surface wear and roughness of experimental composites containing calcium orthophosphate particles following toothbrush abrasion},
journal = {European Journal of Oral Sciences},
year = {2026},
doi = {10.1111/eos.70063}
}
EUVIMED