3D‐printed model for gingival flap surgery simulation: Development and pilot test
European Journal of Dental Education · 2024
DOI: 10.1111/eje.12998 ↗Kurz gefasst
Fachartikel in der Zeitschrift European Journal of Dental Education, 2024. Verfasst von David Antunes und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Oral Surgery, University Hospital of Reims, Reims, France. Hauptthemen laut MEDLINE: Education, Dental, Simulation Training. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 40 Literaturangaben.
Abstract (Originalsprache)
Introduction
To assess the feasibility of a realistic model for learning oral flaps using 3D printing technology. Materials and Methods A mould was designed to reproduce the mandibular gingival mucosa, and a mandibular model was created using a three‐dimensional printer for training undergraduate students to perform gingival flaps. After a short interview about its use, the participants were asked to use the simulator and provide feedback using a 5‐point Likert questionnaire.
Results
The 3D‐printed oral surgery flap training model was practical and inexpensive. The model was very realistic, educational and useful for hands‐on training.
Conclusions
3D printing technology offers new possibilities for training in dental treatments that are currently difficult to replicate. The use of this simulator for oral flap surgery was well‐received and considered promising by the participants.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Oral Surgery, University Hospital of Reims, Reims, France.
- CNRS, Centrale Lille, Univ. Lille, UMR 9013 - LaMcube - Laboratoire de Mécanique, Multiphysique, Multiéchelle, Lille, France.
- University of Reims Champagne-Ardenne, UFR Odontology, Reims, France.
- Univ. Lille, CHU Lille, INSERM, Department of Oral and Maxillofacial Surgery, INSERM U1008 - Advanced Drug Delivery Systems, Lille, France.
ORCID-Profile: David Antunes
Zitieren
APA
Antunes, D., Mayeur, O., Mauprivez, C., & Nicot, R. (2024). 3D‐printed model for gingival flap surgery simulation: Development and pilot test. European Journal of Dental Education. https://doi.org/10.1111/eje.12998
Vancouver
Antunes D, Mayeur O, Mauprivez C, Nicot R. 3D‐printed model for gingival flap surgery simulation: Development and pilot test. European Journal of Dental Education. 2024. doi:10.1111/eje.12998
BibTeX
@article{Antunes2024,
author = {Antunes, David and Mayeur, Olivier and Mauprivez, Cédric and Nicot, Romain},
title = {3D‐printed model for gingival flap surgery simulation: Development and pilot test},
journal = {European Journal of Dental Education},
year = {2024},
doi = {10.1111/eje.12998}
}
EUVIMED