Association Between Osteomeatal Complex Variations and Maxillary Sinus Membrane Thickness: A CBCT Study
Clinical Implant Dentistry and Related Research · 2026
DOI: 10.1111/cid.70121 ↗Kurz gefasst
Fachartikel in der Zeitschrift Clinical Implant Dentistry and Related Research, 2026. Verfasst von Damla Eda Yapıcı Gulbey und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Periodontology, Faculty of Dentistry, Mersin University, Mersin, Turkey. Hauptthemen laut MEDLINE: Cone-Beam Computed Tomography, Maxillary Sinus, Nasal Mucosa. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 71 Literaturangaben.
Abstract (Originalsprache)
Introduction
Perforation is the most common complication of sinus floor elevation (SFE) surgery, and is closely associated with the thickness of the maxillary sinus membrane. This study aimed to evaluate the relationship between maxillary sinus membrane thickness and anatomical variations in the osteomeatal complex (OMC).
Methods
Cone beam computed tomography scans were retrospectively analyzed, encompassing 1957 sinuses. Mucosal thickness (MT) and mucosal appearance (MA) were classified as normal, flat thickening, polypoid thickening, or ostium obstruction. Ostium width (OW), infundibulum length (IL), and ethmoidal bulla diameter (EBD) were measured. The presence of Haller cells (HC), concha bullosa (CB), and superior attachment of the uncinate process (UPSA) was recorded. Kruskal–Wallis, Mann–Whitney U, Chi‐square, and GEE models were used.
Results
Mucosal thickening was observed in 54% of the sinuses, with flat thickening (23.5%) being the most prevalent pattern. A significant association was found between ostium obstruction and MT greater than 10 mm. MT, IL, OW, and EBD values were significantly higher in men than in women. Significant correlations were also identified between MT and IL, OW, EBD, and HC. No significant relationship was found between CB and MT. However, UPSA types 3, 4, and 6 were significantly associated with polypoid thickening and ostium obstruction.
Conclusion
The findings demonstrate that anatomical variations in the OMC influence maxillary sinus membrane thickness. A comprehensive evaluation of these variations should be performed before planning for SFE procedures. Dentists should be proficient in identifying and assessing the osteomeatal region during routine radiographic examinations to prevent potential complications.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Periodontology, Faculty of Dentistry, Mersin University, Mersin, Turkey.
- Department of Radiology, Memorial Diyarbakir Hospital, Diyarbakir, Turkey.
- Department of Biostatistics, Faculty of Medicine, Bolu Abant Izzet Baysal University, Bolu, Turkey.
- Department of Periodontology, Faculty of Dentistry, Hacettepe University, Ankara, Turkey.
- Department of Periodontology, Faculty of Dentistry, Selçuk University, Konya, Turkey.
ORCID-Profile: Damla Eda Yapıcı Gulbey, Abdussamet Batur, Seyit Ali Kayis, Guliz Nigar Guncu, Sema S Hakki
Zitieren
APA
Gulbey, D. E. Y., Batur, A., Kayis, S. A., Guncu, G. N., & Hakki, S. S. (2026). Association Between Osteomeatal Complex Variations and Maxillary Sinus Membrane Thickness: A CBCT Study. Clinical Implant Dentistry and Related Research. https://doi.org/10.1111/cid.70121
Vancouver
Gulbey DEY, Batur A, Kayis SA, Guncu GN, Hakki SS. Association Between Osteomeatal Complex Variations and Maxillary Sinus Membrane Thickness: A CBCT Study. Clinical Implant Dentistry and Related Research. 2026. doi:10.1111/cid.70121
BibTeX
@article{Gulbey2026,
author = {Gulbey, Damla Eda Yapıcı and Batur, Abdussamet and Kayis, Seyit Ali and Guncu, Guliz Nigar and Hakki, Sema S},
title = {Association Between Osteomeatal Complex Variations and Maxillary Sinus Membrane Thickness: A CBCT Study},
journal = {Clinical Implant Dentistry and Related Research},
year = {2026},
doi = {10.1111/cid.70121}
}
EUVIMED