EUVIMEDEUVIMED entdecken
Randomisierte kontrollierte StudieVergleichsstudieOpen Access · CC BY 4.0

Autologous bone harvested during implant bed preparation: A randomized clinical trial comparing high‐speed drilling with irrigation versus low‐speed drilling without irrigation

Juan Carlos Bernabeu-Mira iD, Miguel Peñarrocha-Diago, Luigi Canullo, Fabio Camacho-Alonso iD, Arthur Rodriguez Gonzalez Cortes iD, David Peñarrocha-Oltra iD

Clinical Implant Dentistry and Related Research · 2024

DOI: 10.1111/cid.13346 ↗

Kurz gefasst

Randomisierte kontrollierte Studie in der Zeitschrift Clinical Implant Dentistry and Related Research, 2024. Verfasst von Juan Carlos Bernabeu-Mira und 5 weiteren Autor:innen. Beteiligte Einrichtung: Oral Surgery Unit, Faculty of Medicine and Dentistry, Department of Stomatology, University of Valencia, Valencia, Spain. Hauptthemen laut MEDLINE: Bone Transplantation, Cone-Beam Computed Tomography, Therapeutic Irrigation, Tissue and Organ Harvesting. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

To compare collected bone weight and the frequency of autologous bone harvesting from the flutes of surgical drills used for implant bed preparation using two different drilling techniques. A comparative evaluation of radiographic bone density and bone quality was also made. Materials and Methods A randomized clinical trial was made of 66 dental implants in patients with a single posterior edentulous site. The compared drilling techniques were high‐speed drilling with irrigation (control group) and low‐speed drilling without irrigation (test group). The bone collected in both groups was dried and weighed with a precise electronic balance. The frequency of harvesting was calculated. The median radiographic bone density of each implant site was measured using cone‐beam computed tomography (CBCT) pixel values. Patient sex, age, implant position and dimensions, as well as the last drill diameter were analyzed as independent variables. The level of significance was 5%.

Results

The harvesting of bone chips from drill flutes proved possible in 51.5% of the procedures in the control group and in 100% in the test group ( p < 0.001). There were also statistically significant differences in bone weight between the control group (6.7 ± 10.6 mg) and the test group (41.9 ± 30.3 mg) ( p < 0.001). The CBCT pixel values were directly correlated with the collected bone weight in both groups. The median radiographic bone density, arch and last drill diameter were significantly associated with harvesting bone frequency and collected bone weight ( p < 0.05).

Conclusions

Our findings suggest that the frequency and weight of autologous bone harvested from drills are greater with low‐speed drilling without irrigation than with high‐speed drilling with irrigation. Radiographic bone density, arch and last drill diameter also significantly influenced the harvesting outcomes.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Bone TransplantationCone-Beam Computed TomographyTherapeutic IrrigationTissue and Organ HarvestingAdultAgedFemaleHumansMaleMiddle AgedBone DensityDental Implantation, EndosseousDental ImplantsTransplantation, Autologous

Stichwörter der Autor:innen

autologous bonebiological drillingbone qualitydensitydental implantharvested bonelow‐speed drillingosteotomy

Substanzen

Dental Implants

Autor:innen und Institutionen

  • Oral Surgery Unit, Faculty of Medicine and Dentistry, Department of Stomatology, University of Valencia, Valencia, Spain.
  • University of Genova, Genoa, Italy.
  • Department of Oral Surgery, University of Murcia, Murcia, Spain.
  • Faculty of Dental Surgery, Department of Dental Surgery, University of Malta, Valletta, Malta.

ORCID-Profile: Juan Carlos Bernabeu-Mira, Fabio Camacho-Alonso, Arthur Rodriguez Gonzalez Cortes, David Peñarrocha-Oltra

Zitieren

APA

Bernabeu-Mira, J. C., Peñarrocha-Diago, M., Canullo, L., Camacho-Alonso, F., Cortes, A. R. G., & Peñarrocha-Oltra, D. (2024). Autologous bone harvested during implant bed preparation: A randomized clinical trial comparing high‐speed drilling with irrigation versus low‐speed drilling without irrigation. Clinical Implant Dentistry and Related Research. https://doi.org/10.1111/cid.13346

Vancouver

Bernabeu-Mira JC, Peñarrocha-Diago M, Canullo L, Camacho-Alonso F, Cortes ARG, Peñarrocha-Oltra D. Autologous bone harvested during implant bed preparation: A randomized clinical trial comparing high‐speed drilling with irrigation versus low‐speed drilling without irrigation. Clinical Implant Dentistry and Related Research. 2024. doi:10.1111/cid.13346

BibTeX
@article{BernabeuMira2024,
  author = {Bernabeu-Mira, Juan Carlos and Peñarrocha-Diago, Miguel and Canullo, Luigi and Camacho-Alonso, Fabio and Cortes, Arthur Rodriguez Gonzalez and Peñarrocha-Oltra, David},
  title = {Autologous bone harvested during implant bed preparation: A randomized clinical trial comparing high‐speed drilling with irrigation versus low‐speed drilling without irrigation},
  journal = {Clinical Implant Dentistry and Related Research},
  year = {2024},
  doi = {10.1111/cid.13346}
}
Kostenlos starten →