Curvature‐matched 5‐axis CNC machining using non‐circular toroidal cutters
Computer Graphics Forum · 16.11.2026
DOI: 10.1111/cgf.70639 ↗Kurz gefasst
Fachartikel in der Zeitschrift Computer Graphics Forum, online erschienen am 16.11.2026. Verfasst von K. Kruppa und 3 weiteren Autor:innen. Die Arbeit nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Eusko Jaurlaritza, Ministerio de Ciencia e Innovación, Basque Center for Applied Mathematics.
Abstract (Originalsprache)
Highly accurate 5‐axis CNC machining requires a good, ideally higher order, match between the cutting tool and the reference surface along a common tangent direction. It has been shown that one can apply this, so‐called curvature matching, even to convex surfaces using circular toroidal tools, by exploiting their interior hyperbolic points [BBR*21]. However, such an approach typically requires a large tool and is very restrictive in terms of motion planning due to possible global collisions between the tool and the material block. In contrast, in this work we consider toroidal tools with non‐convex inserts, which allow us to bring the hyperbolic points to the exterior side of the toroidal cutters, and therefore enable curvature‐matched machining without requiring large tools or restricting tool movability. The proposed framework is compared against path‐ and motion‐planning using classical circular tori on several benchmark geometries and demonstrates the superior behavior of cutting tools that have both elliptic and hyperbolic points on the cutting edge.
Förderung
- Eusko Jaurlaritza
- Ministerio de Ciencia e Innovación
- Basque Center for Applied Mathematics
- Natural Science Foundation of Shandong Province
Zitieren
APA
Kruppa, K., Bizzarri, M., Bo, P., & Bartoň, M. (2026). Curvature‐matched 5‐axis CNC machining using non‐circular toroidal cutters. Computer Graphics Forum. https://doi.org/10.1111/cgf.70639
Vancouver
Kruppa K, Bizzarri M, Bo P, Bartoň M. Curvature‐matched 5‐axis CNC machining using non‐circular toroidal cutters. Computer Graphics Forum. 2026. doi:10.1111/cgf.70639
BibTeX
@article{Kruppa2026,
author = {Kruppa, K. and Bizzarri, M. and Bo, P. and Bartoň, M.},
title = {Curvature‐matched 5‐axis CNC machining using non‐circular toroidal cutters},
journal = {Computer Graphics Forum},
year = {2026},
doi = {10.1111/cgf.70639}
}
EUVIMED