EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The effect of conventional and ohmic heating as pasteurization methods on the mechanical and rheological properties of edible whey‐based films

Elvidas Aleksandrovas iD, Agnė Vasiliauskaitė, Jorge M Vieira, Joana T Martins, Ricardo N Pereira, Antonio A Vicente, Vitalijs Radenkovs, Ida Rud, Mindaugas Malakauskas, Loreta Šernienė

Journal of Food Science · 2025

DOI: 10.1111/1750-3841.70180 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Food Science, 2025. Verfasst von Elvidas Aleksandrovas und 9 weiteren Autor:innen. Beteiligte Einrichtung: Department of Food Safety and Quality, Veterinary Academy, Lithuanian University of Health Sciences, Kaunas, Lithuania. Hauptthemen laut MEDLINE: Pasteurization, Whey Proteins, Edible Films, Whey. Die Arbeit nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Intramural NIH HHS, EEA Grants/Norway Grants, Portuguese Foundation for Science and Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Edible film‐forming solutions typically undergo thermal treatment to ensure microbial safety before being applied to food products. The aim of this study was to assess the effects of two different heating methods—conventional heating (CH) and ohmic heating (OH)—on the physical, chemical, and microbiological properties of liquid acid whey permeate (AWP) and liquid acid whey protein concentrate (AWPC) edible films. Composition of edible film‐forming solutions consisted of AWPC, sunflower oil, sugar beet pectin, and glycerol, whereas AWP‐based films were produced with sugar beet pectin and glycerol. The following parameters were tested to assess the effect of heating treatments on the film‐forming solutions: rheology, contact angle [CA] and microbial counts and mechanical properties (tensile strength [TS] and elongation at break [EB]), water vapor permeability [WVP], moisture content [MC], solubility (Sol), and thickness with optical properties of produced edible films. In addition, film surface was investigated by scanning electron microscopy [SEM]. Microbiological analysis of the untreated film‐forming solutions revealed that the AWPC‐based solution had a higher initial load of lactic acid bacteria (3.96 log 10 CFU/mL) ( p < 0.05). Both heating treatments successfully reduced microbial counts to below detection limits in both film‐forming solutions. Additionally, OH treatment resulted in lower CA values in both solutions ( p < 0.05). OH also led to an increase in TS for AWP‐based edible films ( p < 0.05) and significantly reduced the thickness of both AWP and AWPC films, while reducing the Sol of AWP‐based films and increasing the Sol of AWPC‐based films ( p < 0.05). The study highlights the effectiveness of the two pasteurization methods and offers insights into improving whey‐based edible films.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

PasteurizationWhey ProteinsEdible FilmsWheyRheologyHot TemperatureTensile StrengthFood MicrobiologyFood PackagingPermeability

Stichwörter der Autor:innen

acid whey permeateconventional heatingedible filmsliquid acid whey protein concentrateohmic heating

Substanzen

Whey Proteins

Autor:innen und Institutionen

  • Department of Food Safety and Quality, Veterinary Academy, Lithuanian University of Health Sciences, Kaunas, Lithuania.
  • Centre of Biological Engineering (CEB), University of Minho, Campus de Gualtar, Braga, Portugal.
  • LABBELS-Associate Laboratory, Braga/Guimarães, Portugal.
  • Research Laboratory of Biotechnology, Division of Smart Technologies, Latvia University of Life Sciences and Technologies, Jelgava, Latvia.
  • Institute of Horticulture (LatHort), Dobele, Latvia.
  • Fisheries and Aquaculture Research, Norwegian Institute of Food, Nofima, Ås, Norway.

ORCID-Profile: Elvidas Aleksandrovas

Förderung

  • Intramural NIH HHS
  • EEA Grants/Norway Grants
  • Portuguese Foundation for Science and Technology
  • LABBELS-Associate Laboratory in Biotechnology

Zitieren

APA

Aleksandrovas, E., Vasiliauskaitė, A., Vieira, J. M., Martins, J. T., Pereira, R. N., Vicente, A. A., Radenkovs, V., Rud, I., Malakauskas, M., & Šernienė, L. (2025). The effect of conventional and ohmic heating as pasteurization methods on the mechanical and rheological properties of edible whey‐based films. Journal of Food Science. https://doi.org/10.1111/1750-3841.70180

Vancouver

Aleksandrovas E, Vasiliauskaitė A, Vieira JM, Martins JT, Pereira RN, Vicente AA, et al. The effect of conventional and ohmic heating as pasteurization methods on the mechanical and rheological properties of edible whey‐based films. Journal of Food Science. 2025. doi:10.1111/1750-3841.70180

BibTeX
@article{Aleksandrovas2025,
  author = {Aleksandrovas, Elvidas and Vasiliauskaitė, Agnė and Vieira, Jorge M and Martins, Joana T and Pereira, Ricardo N and Vicente, Antonio A and Radenkovs, Vitalijs and Rud, Ida and Malakauskas, Mindaugas and Šernienė, Loreta},
  title = {The effect of conventional and ohmic heating as pasteurization methods on the mechanical and rheological properties of edible whey‐based films},
  journal = {Journal of Food Science},
  year = {2025},
  doi = {10.1111/1750-3841.70180}
}
Kostenlos starten →