Accelerated Aging of HV Metallized Polypropylene Film Capacitors at Sub-kHz Pulsing and Elevated Temperature
IEEE Transactions on Plasma Science · 2026-02 · 54 (2) · 615-622
DOI: 10.1109/tps.2026.3653655 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Transactions on Plasma Science, 2026-02. Verfasst von Alex Pokryvailo und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 23 Literaturangaben. Gefördert von: Spellman High Voltage Electronics Corporation.
Abstract (Originalsprache)
Aging of three types of 5-nF, 15-kV multisectioned metallized polypropylene (PP) capacitors was investigated under pulsed conditions, typically at 13.7 kV and 500 Hz, up to a hundred of millions of shots. Two of the types are built with regular PP specified up to $105~^{\circ }$ C, and the third type, dubbed “HT,” uses a high-temperature PP film specified up to $130~^{\circ }$ C. All parts were tested at room temperature (RT), $85~^{\circ }$ C, and $100~^{\circ }$ C, and HT parts were tested at $130~^{\circ }$ C. Control tests were done at dc at the same voltage, at $100~^{\circ }$ C. In addition, selected parts were subjected to pure thermal aging at $100~^{\circ }$ C. The rationale of pulsed testing was a highly accelerated aging compared to dc aging. Aging of the three capacitor types at different temperatures shows a tendency of aging being independent of temperature (in the specified ranges) at a large number of shots. Based on the results obtained with different discharge loads, it was concluded that the discharge current has no appreciable impact on aging at current levels typical for high voltage power supplies (HVPSs); voltage is the dominant factor. Pulsed aging results in capacitance loss (CL) of several percent at millions of pulses, whereas dc aging at the same and even higher voltages for more than 1000 hr yielded CL of fractions of a percent only. CL empirical fits using inverse power law are also offered. One regular PP type lost capacitance through self-healing, with the film exhibiting clearings’ pockmarks; the films of the other two types did not have the same pattern. The HT film was partially fused; the film of the other regular PP type that lost more than 10% of capacitance was largely indistinguishable from a fresh film, except for receding metallization edges. The edge recession, as evidenced by microphotography, caused by electrochemical corrosion, is responsible for CL.
Förderung
- Spellman High Voltage Electronics Corporation
Zitieren
APA
Pokryvailo, A., & Felicetta, A. (2026). Accelerated Aging of HV Metallized Polypropylene Film Capacitors at Sub-kHz Pulsing and Elevated Temperature. IEEE Transactions on Plasma Science, 54(2), 615-622. https://doi.org/10.1109/tps.2026.3653655
Vancouver
Pokryvailo A, Felicetta A. Accelerated Aging of HV Metallized Polypropylene Film Capacitors at Sub-kHz Pulsing and Elevated Temperature. IEEE Transactions on Plasma Science. 2026;54(2):615-622. doi:10.1109/tps.2026.3653655
BibTeX
@article{Pokryvailo2026,
author = {Pokryvailo, Alex and Felicetta, A.},
title = {Accelerated Aging of HV Metallized Polypropylene Film Capacitors at Sub-kHz Pulsing and Elevated Temperature},
journal = {IEEE Transactions on Plasma Science},
year = {2026},
volume = {54},
number = {2},
pages = {615--622},
doi = {10.1109/tps.2026.3653655}
}
EUVIMED