Design of a Second Harmonic Reradiating Rectenna Using Harmonic Source Pull
IEEE Transactions on Microwave Theory and Techniques · 2024-10 · 72 (10) · 6164-6173
DOI: 10.1109/tmtt.2024.3387543 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Transactions on Microwave Theory and Techniques, 2024-10. Verfasst von Katsumi Kawai und 2 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 21 Literaturangaben. Gefördert von: Japan Society for the Promotion of Science (JSPS), Grants-in-Aid for Scientific Research.
Abstract (Originalsprache)
This study proposes a design method for rectennas that provide high RF–dc conversion efficiency and enhanced second harmonic reradiation levels by employing source-pull simulation with harmonics. Reusing a harmonic generated by a rectenna is an advantageous retrodirective system, because harmonic reradiation can be used as a battery-less pilot signal. In this retrodirective system, it is essential to ensure that a rectenna effectively reradiates harmonics with high RF–dc conversion efficiency. The proposed design method allows a rectenna to effectively facilitate second harmonic reradiation without additional filters. The source-pull simulation was conducted on a single-series rectifier circuit, revealing the correlation between the RF–dc conversion efficiency and the second harmonic reradiation level, with specific source impedance values at each harmonic. An inverted-F antenna with a short-circuit stub on the back side was designed based on the source-pull simulation results. The designed rectenna has an RF–dc conversion efficiency of 60.6% and a second harmonic reradiation level of 0.17 dBm at a frequency of 920 MHz, with an input power of 10.0 dBm and a load resistance of 1.0 k ${\Omega }$ . This design performs much better than previous designs regarding the harmonic reradiation level while maintaining a high RF–dc conversion efficiency.
Förderung
- Japan Society for the Promotion of Science (JSPS), Grants-in-Aid for Scientific Research
Zitieren
APA
Kawai, K., Shinohara, N., & Mitani, T. (2024). Design of a Second Harmonic Reradiating Rectenna Using Harmonic Source Pull. IEEE Transactions on Microwave Theory and Techniques, 72(10), 6164-6173. https://doi.org/10.1109/tmtt.2024.3387543
Vancouver
Kawai K, Shinohara N, Mitani T. Design of a Second Harmonic Reradiating Rectenna Using Harmonic Source Pull. IEEE Transactions on Microwave Theory and Techniques. 2024;72(10):6164-6173. doi:10.1109/tmtt.2024.3387543
BibTeX
@article{Kawai2024,
author = {Kawai, Katsumi and Shinohara, Naoki and Mitani, Tomohiko},
title = {Design of a Second Harmonic Reradiating Rectenna Using Harmonic Source Pull},
journal = {IEEE Transactions on Microwave Theory and Techniques},
year = {2024},
volume = {72},
number = {10},
pages = {6164--6173},
doi = {10.1109/tmtt.2024.3387543}
}
EUVIMED