EUVIMEDEUVIMED entdecken
Crossref

A Fully Integrated Stimulator With High Electrode Voltage Using Hybrid Dynamic Bulk Biasing Technique and Charge-Pump-Like Control Technique in a Bulk CMOS Technology

Yixin Zhou, Jialei Wu, Simeng Yin, Zihan Li, Zhijun Zhou, Wen-Yuan Li, Zhi-Gong Wang, Fanyi Meng, Kiat Seng Yeo, Kaixue Ma, Keping Wang

IEEE Transactions on Circuits and Systems I: Regular Papers · 2026-08 · 73 (8) · 5354-5365

DOI: 10.1109/tcsi.2026.3675619 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Transactions on Circuits and Systems I: Regular Papers, 2026-08. Verfasst von Yixin Zhou und 10 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Gefördert von: National Key Research and Development Program of China, National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a fully integrated NMOS stimulator using a hybrid dynamic bulk biasing technique (HDBT) and a charge-pump-like control technique (CCT) in a 180-nm bulk CMOS technology. HDBT integrates terminal-voltage-dependent and logic dynamic bulk biasing to set the bulk bias voltage according to the electrode voltage. CCT adds a DC voltage to the gate terminal through a diode and capacitor to help turn on the NMOS transistor. It helps turn off the transistor by shorting the source and gate terminals together and applying two diodes across the drain and source terminals. To achieve an electrode voltage higher than the breakdown voltage of substrate diode ( $V_{\mathrm {BD}}$ ) with an independent power supply, a high voltage tolerant switch is proposed with HDBT and CCT. A high voltage interface is also proposed, utilizing the capacitor adaptive biasing, to overcome the limitation of $V_{\mathrm {BD}}$ between the high and low voltage domains and to accommodate the variation of electrode voltage. Fabricated in a 180-nm standard CMOS technology, the stimulator achieves a maximum electrode voltage ( $V_{\mathrm {E,MAX}}$ ) of 18.74V under a 3.3-V supply, with a highest $V_{\mathrm {E,MAX}}$ / $V_{\mathrm {BD}}$ ratio of 1.27 than state-of-the-art stimulators, including non-standard technology designs. In a continuous output test mode over 10 million cycles, the variation of $V_{\mathrm {E,MAX}}$ is less than 150mV. The measured maximum residual voltage on the capacitor is 13.55mV.

Förderung

  • National Key Research and Development Program of China
  • National Natural Science Foundation of China

Zitieren

APA

Zhou, Y., Wu, J., Yin, S., Li, Z., Zhou, Z., Li, W., Wang, Z., Meng, F., Yeo, K. S., Ma, K., & Wang, K. (2026). A Fully Integrated Stimulator With High Electrode Voltage Using Hybrid Dynamic Bulk Biasing Technique and Charge-Pump-Like Control Technique in a Bulk CMOS Technology. IEEE Transactions on Circuits and Systems I: Regular Papers, 73(8), 5354-5365. https://doi.org/10.1109/tcsi.2026.3675619

Vancouver

Zhou Y, Wu J, Yin S, Li Z, Zhou Z, Li W, et al. A Fully Integrated Stimulator With High Electrode Voltage Using Hybrid Dynamic Bulk Biasing Technique and Charge-Pump-Like Control Technique in a Bulk CMOS Technology. IEEE Transactions on Circuits and Systems I: Regular Papers. 2026;73(8):5354-5365. doi:10.1109/tcsi.2026.3675619

BibTeX
@article{Zhou2026,
  author = {Zhou, Yixin and Wu, Jialei and Yin, Simeng and Li, Zihan and Zhou, Zhijun and Li, Wen-Yuan and Wang, Zhi-Gong and Meng, Fanyi and Yeo, Kiat Seng and Ma, Kaixue and Wang, Keping},
  title = {A Fully Integrated Stimulator With High Electrode Voltage Using Hybrid Dynamic Bulk Biasing Technique and Charge-Pump-Like Control Technique in a Bulk CMOS Technology},
  journal = {IEEE Transactions on Circuits and Systems I: Regular Papers},
  year = {2026},
  volume = {73},
  number = {8},
  pages = {5354--5365},
  doi = {10.1109/tcsi.2026.3675619}
}
Kostenlos starten →