A 23-41 GHz Broadband Power Amplifier With Common-Mode Stability Enhancement Technique in 65-nm CMOS Process
IEEE Transactions on Circuits and Systems I: Regular Papers · 2025-11 · 72 (11) · 6872-6885
DOI: 10.1109/tcsi.2025.3563467 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Transactions on Circuits and Systems I: Regular Papers, 2025-11. Verfasst von Chenxi Zhao und 5 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 42 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Natural Science Foundation of Sichuan.
Abstract (Originalsprache)
Here, we present a millimeter-wave (mm-Wave) broadband power amplifier (PA) with a common-mode (CM) stability improvement technique. Unlike conventional broadband PAs, which consider only the differential-mode (DM) stability, our proposed PA simultaneously enhances the DM stability and the CM stability. To ensure CM stability, a small resistor is first connected in series to a capacitor to reduce its Q factor; then, these components are attached in parallel at the center tap of the input balun to increase the CM path loss. Therefore, the stabilization of the PA can be improved over the entire frequency band to ensure a properly broadband work. Our proposed broadband PA with CM stability enhancement technique is finished in a commercial 65 nm CMOS process with a core area of 0.13 mm2. Adopting continuous-wave testing, the PA exhibits 56.3% 1-dB output 1-dB compression point power ( $OP_{1dB}$ ) fractional bandwidth and 3-dB small signal gain fractional bandwidth from 23 to 41 GHz that covers the whole Ka-band. At 28/39 GHz, the PA provides +14.8-/+14.1-dBm saturation output power ( $P_{sat}$ ), +12.4-/+12.0-dBm $OP_{1dB}$ and 29.8%/23.8% peak power added efficiency (PAE). The measured stability parameters indicate the proposed CM stability enhanced broadband PA is unconditionally stable over the entire frequency band. For a 100-MHz 1-CC 64-QAM signals (roll-off factor =0.45 and PAPR =7.1 dB), at a carrier frequency of 28 GHz, the PA demonstrates 8.6 dBm average output power ( $P_{avg}$ ), 5% average power added efficiency ( $PAE_{avg}$ ), −32.4 dBc adjacent channel leakage ratio (ACLR) and −25.4 dB EVM. For a 400-MHz single-carrier 64-QAM signal, this proposed PA still provides 8.1-dBm $P_{avg}$ and 4.5% $PAE_{avg}$ with a −34.2 dBc ACLR and −25.3 dB rms EVM at 28 GHz.
Förderung
- National Natural Science Foundation of China
- Natural Science Foundation of Sichuan
Zitieren
APA
Zhao, C., Liu, M., Liu, H., Yu, Y., Wu, Y., & Kang, K. (2025). A 23-41 GHz Broadband Power Amplifier With Common-Mode Stability Enhancement Technique in 65-nm CMOS Process. IEEE Transactions on Circuits and Systems I: Regular Papers, 72(11), 6872-6885. https://doi.org/10.1109/tcsi.2025.3563467
Vancouver
Zhao C, Liu M, Liu H, Yu Y, Wu Y, Kang K. A 23-41 GHz Broadband Power Amplifier With Common-Mode Stability Enhancement Technique in 65-nm CMOS Process. IEEE Transactions on Circuits and Systems I: Regular Papers. 2025;72(11):6872-6885. doi:10.1109/tcsi.2025.3563467
BibTeX
@article{Zhao2025,
author = {Zhao, Chenxi and Liu, Mengxuan and Liu, Huihua and Yu, Yiming and Wu, Yunqiu and Kang, Kai},
title = {A 23-41 GHz Broadband Power Amplifier With Common-Mode Stability Enhancement Technique in 65-nm CMOS Process},
journal = {IEEE Transactions on Circuits and Systems I: Regular Papers},
year = {2025},
volume = {72},
number = {11},
pages = {6872--6885},
doi = {10.1109/tcsi.2025.3563467}
}
EUVIMED