Delay Mismatch Insensitive Dead Time Generator for High-Voltage Switched-Mode Power Amplifiers
IEEE Transactions on Circuits and Systems I: Regular Papers · 2023-04 · 70 (4) · 1555-1565
DOI: 10.1109/tcsi.2022.3232074 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Transactions on Circuits and Systems I: Regular Papers, 2023-04. Verfasst von Ahmed Abuelnasr und 6 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 27 Literaturangaben. Gefördert von: Natural Sciences and Engineering Research Council of Canada, Mathematics of Information Technology and Complex System.
Abstract (Originalsprache)
The Design of efficient, safe, and reliable circuits is a prime objective in high-voltage (HV) electronic systems, such as switched-mode power amplifiers (PAs). One of the main causes of efficiency degradation and reliability problems, in these amplifiers, is the shoot-through current from the HV power supply to the ground. To eliminate such current, a dead time generator (DTG) is used to modify the signals propagating through the high-side and low-side gate drivers by adding a fixed dead time between them. However, any delay mismatch between these gate drivers can reduce the dead time to the point that it becomes negative. In this paper, an HV-DTG architecture is introduced. The architecture mitigates the effects of delay mismatch variations in gate drivers, which can result from parameters mismatch, fabrication process variations, and temperature variations. An HV switched-mode class-D power amplifier is used to illustrate the performance of the DTG. The amplifier is implemented in a low-cost $0.35~\mu m$ HV CMOS process. The total area of the PA is $0.5~mm^{2}$ , where the DTG covers an area of $0.066~mm^{2}$ . A measured system’s efficiency of 95.14% is achieved with the shortest dead time of 10.8 ns, which is 1.38x smaller than the generated dead time in comparable state-of-the-art HV dead time generators.
Förderung
- Natural Sciences and Engineering Research Council of Canada
- Mathematics of Information Technology and Complex System
Zitieren
APA
Abuelnasr, A., Amer, M., Ali, M., Hassan, A., Gosselin, B., Ragab, A., & Savaria, Y. (2023). Delay Mismatch Insensitive Dead Time Generator for High-Voltage Switched-Mode Power Amplifiers. IEEE Transactions on Circuits and Systems I: Regular Papers, 70(4), 1555-1565. https://doi.org/10.1109/tcsi.2022.3232074
Vancouver
Abuelnasr A, Amer M, Ali M, Hassan A, Gosselin B, Ragab A, et al. Delay Mismatch Insensitive Dead Time Generator for High-Voltage Switched-Mode Power Amplifiers. IEEE Transactions on Circuits and Systems I: Regular Papers. 2023;70(4):1555-1565. doi:10.1109/tcsi.2022.3232074
BibTeX
@article{Abuelnasr2023,
author = {Abuelnasr, Ahmed and Amer, Mostafa and Ali, Mohamed and Hassan, Ahmad and Gosselin, Benoit and Ragab, Ahmed and Savaria, Yvon},
title = {Delay Mismatch Insensitive Dead Time Generator for High-Voltage Switched-Mode Power Amplifiers},
journal = {IEEE Transactions on Circuits and Systems I: Regular Papers},
year = {2023},
volume = {70},
number = {4},
pages = {1555--1565},
doi = {10.1109/tcsi.2022.3232074}
}
EUVIMED