EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A Vehicle-in-the-Loop Approach for Front Camera Verification Using Adaptive High Beam

Robin Langer, Thomas Tentrup, Hans-Georg Schweiger

IEEE Open Journal of Intelligent Transportation Systems · 2026 · 7 · 799-821

DOI: 10.1109/ojits.2026.3672438 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Open Journal of Intelligent Transportation Systems, 2026. Verfasst von Robin Langer und 2 weiteren Autor:innen. Die Arbeit nennt 56 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Bundesministerium f?r Bildung und Forschung.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

As automated driving functions based on environmental sensors become increasingly deployed, ensuring reliable performance over the vehicle lifetime is essential. Currently, verification is carried out through internal self-diagnostics, which do not always operate correctly, and periodic technical inspection, which assesses only the test criteria installation and condition. Test criteria for function and efficiency of environmental sensors are neither standardized nor routinely assessed, creating the need for new testing approaches. Previous low-cost research approaches defined a method and conducted experiments to verify a vehicle’s front camera by displaying visual stimuli and evaluating the high beam assist response. Whereas the camera’s function could be verified through a basic qualitative check, the approach did not enable a quantitative evaluation of its performance. The aim of this work was therefore to advance this approach and investigate the added value of a Vehicle-in-the-Loop test bench for front camera verification. Three tests were conducted. A supporting method was introduced to reproducibly detect and define the position of the headlight cutoff line, enabling consistent evaluation of the vehicle’s reaction. With static camera stimuli (Test I), the function of the front camera could be verified, and the influence of the vehicle geometry on the reaction was assessed. Dynamic stimuli (Test II) additionally enabled an efficiency evaluation, allowing quantitative comparison between vehicles. However, transferring the stimuli into a reproducible virtual simulation (Test III) remained challenging, as the vehicles under test did not respond consistently. Further research is required to refine and simplify the method toward a standardized periodic technical inspection procedure.

Förderung

  • Bundesministerium f?r Bildung und Forschung

Zitieren

APA

Langer, R., Tentrup, T., & Schweiger, H. (2026). A Vehicle-in-the-Loop Approach for Front Camera Verification Using Adaptive High Beam. IEEE Open Journal of Intelligent Transportation Systems, 7, 799-821. https://doi.org/10.1109/ojits.2026.3672438

Vancouver

Langer R, Tentrup T, Schweiger H. A Vehicle-in-the-Loop Approach for Front Camera Verification Using Adaptive High Beam. IEEE Open Journal of Intelligent Transportation Systems. 2026;7:799-821. doi:10.1109/ojits.2026.3672438

BibTeX
@article{Langer2026,
  author = {Langer, Robin and Tentrup, Thomas and Schweiger, Hans-Georg},
  title = {A Vehicle-in-the-Loop Approach for Front Camera Verification Using Adaptive High Beam},
  journal = {IEEE Open Journal of Intelligent Transportation Systems},
  year = {2026},
  volume = {7},
  pages = {799--821},
  doi = {10.1109/ojits.2026.3672438}
}
Kostenlos starten →