EUVIMEDEUVIMED entdecken
Crossref

10-GSymbols/s Supply-Modulated APSK C SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power

Haidong Guo, Suprovo Ghosh, Frank Zhang, Suhwan Lee, Wooyeol Choi, Shenggang Dong, Ibukunoluwa Momson, Karl Strecker, Kenneth K. O

IEEE Journal of Solid-State Circuits · 2025-09 · 60 (9) · 3082-3094

DOI: 10.1109/jssc.2025.3575769 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Journal of Solid-State Circuits, 2025-09. Verfasst von Haidong Guo und 8 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 45 Literaturangaben. Gefördert von: SRC Joint University Microelectronic Program (JUMP) and DARPA, Regents of the University of California.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This article presents a 250-GHz supply-modulated SiGe heterojunction bipolar transistor (HBT) ( $f_{T}$ and $f_{\max }$ of 350 and 450 GHz, respectively) transmitter RF front end that integrates a transformer-coupled four-stage power amplifier (PA) whose fourth stage is supply-modulated at a symbol rate of 10 GSymbols/s utilizing a high-speed low-dropout regulator (LDO). An integrated LO chain with a frequency multiplier generates a 121-GHz LO signal. Additionally, on-chip bipolar current-mode logic circuits are used to decode 1- or 2-bit PRBS data stream(s) and to drive the LDO that implements two- or four-level supply modulation. The transmitter supports 16-customized-APSK and 32-customized-APSK constellations, achieving instrumentation-limited data rates of 40 and 50 Gb/s with the peak modulated output power of 6.8 dBm and error vector magnitudes (EVMs) of −18.9 and −20.4 dB, respectively, while consuming approximately 1 W of dc power. The use of supply modulation with the APSK modulations increases both the peak modulated output power and RF-to-dc efficiency by $3{\times }$ and $2{\times }$ , respectively, compared to when conventional quadrature amplitude modulation (QAM) modulation with power backoff is employed. The measured 6.8-dBm peak modulated power is the highest for a transmitter IC operating at this frequency range.

Förderung

  • SRC Joint University Microelectronic Program (JUMP) and DARPA
  • Regents of the University of California

Zitieren

APA

Guo, H., Ghosh, S., Zhang, F., Lee, S., Choi, W., Dong, S., Momson, I., Strecker, K., & O, K. K. (2025). 10-GSymbols/s Supply-Modulated APSK C SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power. IEEE Journal of Solid-State Circuits, 60(9), 3082-3094. https://doi.org/10.1109/jssc.2025.3575769

Vancouver

Guo H, Ghosh S, Zhang F, Lee S, Choi W, Dong S, et al. 10-GSymbols/s Supply-Modulated APSK C SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power. IEEE Journal of Solid-State Circuits. 2025;60(9):3082-3094. doi:10.1109/jssc.2025.3575769

BibTeX
@article{Guo2025,
  author = {Guo, Haidong and Ghosh, Suprovo and Zhang, Frank and Lee, Suhwan and Choi, Wooyeol and Dong, Shenggang and Momson, Ibukunoluwa and Strecker, Karl and O, Kenneth K.},
  title = {10-GSymbols/s Supply-Modulated APSK C SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power},
  journal = {IEEE Journal of Solid-State Circuits},
  year = {2025},
  volume = {60},
  number = {9},
  pages = {3082--3094},
  doi = {10.1109/jssc.2025.3575769}
}
Kostenlos starten →