EUVIMEDEUVIMED entdecken
Crossref

Single-Ended PAM-4 Transmitters With Data Bus Inversion and ZQ Calibration for High-Speed Memory Interfaces

Seongcheol Kim, Jincheol Sim, Yoonjae Choi, Jonghyuck Choi, Youngwook Kwon, Seungwoo Park, Changmin Sim, Junseob So, Taehyeong Park, Chulwoo Kim

IEEE Journal of Solid-State Circuits · 2024-10 · 59 (10) · 3432-3443

DOI: 10.1109/jssc.2024.3403149 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Journal of Solid-State Circuits, 2024-10. Verfasst von Seongcheol Kim und 9 weiteren Autor:innen. Die Arbeit wurde bisher 14-mal zitiert (Crossref) und nennt 22 Literaturangaben. Gefördert von: National Research and Development Program through the National Research Foundation of Korea funded by the Ministry of Science and ICT.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This article presents the use of pulse amplitude modulation four-level (PAM-4) transmitters (TXs) with pseudo-open drain (POD) termination for single-ended dynamic random access memory (DRAM) interfaces. To address the issues of increased power consumption and susceptibility to noise due to reduced signal-to-noise ratio (SNR), the use of data bus inversion (DBI) is implemented and investigated. By adopting the DBI technique in PAM-4 signaling, the driver power and supply fluctuations can be mitigated while preserving the pin overhead of one for the PAM-4-modulated DBI flag. On every single channel of the TX, the addition of a capacitive-coupled feed-forward equalizer (CC-FFE) is utilized to alleviate inter-symbol interference (ISI) effects. In addition, a reference impedance (ZQ) calibration method enabling the precise adjustment of ZQ values using variation-mitigated on-chip resistors is proposed. By utilizing the proposed ZQ calibration method, the driver’s output impedance can be precisely adjusted under practical operating conditions while maintaining the off-chip cost for one reference resistor. The single-channel TX operates at data rates of up to 38 Gb/s while consuming 26.16 mW of power, which corresponds to a calculated energy efficiency of 0.688 pJ/bit. A 16.3% power dissipation reduction was measured in the drivers as a result of the PAM-4 DBI.

Förderung

  • National Research and Development Program through the National Research Foundation of Korea funded by the Ministry of Science and ICT

Zitieren

APA

Kim, S., Sim, J., Choi, Y., Choi, J., Kwon, Y., Park, S., Sim, C., So, J., Park, T., & Kim, C. (2024). Single-Ended PAM-4 Transmitters With Data Bus Inversion and ZQ Calibration for High-Speed Memory Interfaces. IEEE Journal of Solid-State Circuits, 59(10), 3432-3443. https://doi.org/10.1109/jssc.2024.3403149

Vancouver

Kim S, Sim J, Choi Y, Choi J, Kwon Y, Park S, et al. Single-Ended PAM-4 Transmitters With Data Bus Inversion and ZQ Calibration for High-Speed Memory Interfaces. IEEE Journal of Solid-State Circuits. 2024;59(10):3432-3443. doi:10.1109/jssc.2024.3403149

BibTeX
@article{Kim2024,
  author = {Kim, Seongcheol and Sim, Jincheol and Choi, Yoonjae and Choi, Jonghyuck and Kwon, Youngwook and Park, Seungwoo and Sim, Changmin and So, Junseob and Park, Taehyeong and Kim, Chulwoo},
  title = {Single-Ended PAM-4 Transmitters With Data Bus Inversion and ZQ Calibration for High-Speed Memory Interfaces},
  journal = {IEEE Journal of Solid-State Circuits},
  year = {2024},
  volume = {59},
  number = {10},
  pages = {3432--3443},
  doi = {10.1109/jssc.2024.3403149}
}
Kostenlos starten →